I 'm referring to the cone of the lug nut not the socket size. The 60 degree cone is 1 inch in diameter. I can only find lug nuts with a 60 degree cone size less than 1 inch.
Nugget
Help.
I need to replace some of my 9/16 -18 lugnuts on my 2009 sundance.
The nuts have a chrome cover and the cone is 1 inch in diameter.
I found some that do not have a chrome cover and the cone is less than 1 inch in diameter and seem too small for the aluminum rims.
Where can I get 9/16 -18...
Hello.
The vinyl flooring in my 9 year old Heartland Sundance 5th wheel ripped right across the floor as a result of the cold winter weather (minus 38). It was in a storage shed when it ripped.
I would like your thoughts as to what replacement flooring to use. Vinyl sheet or plank? laminate...
Hey all
Thanks for your thoughts. I will rethink making a "teeter totter" to raise the 4 wheels. Sounds too risky. Undercarriage servicing has been put on hold until the weather warms up. I have a new problem i will post under Interior.
Hello
To maintain and service the undercarriage of my Heartland Sundance 5th wheel I would like to lift all 4 wheels off the ground at the same time.
Would this work?
1. On a hard level surface use trailer landing gear to raise the front of the trailer until some weight is off the front...
I'm interested.
My gear has a lippert high speed motor, 7149 rpm 35,3:1 gear ratio tied to a venture leg and gear assembly.
If yours is the same could your lead leg be used to replace my follow leg?
Would it work?
Timely. My landing gear motor has had a hard time raising the front of the trailer since new. It frequently blew the 20 amp fuse so I went to a 30 amp. The motor still works hard when raising with shore power or truck power connected.
I am considering going to a dual landing gear system hoping...
Help
I own a sundance 3300sk 5th wheel.
VIN# 5SFGF33249E032054
When raising the front of the trailer when it is off the truck the motor works very hard and frequently blows the 30 amp fuse. It has done this since new.
I believe the motor is not strong enough to raise the front properly...
Help
I have a 2009 sundance 3300sk
Since new the landing geear motor has a hard time raising the front of the trailer.
The motor labors to the point where sometimes it blows a fuse.
In winter when cold it cannot seem to raise the front of the trailer even when the trailer is empty.
How can I...
The range hood exhaust fan (12vdc) in my 2009 3300sk is very noisy. Is there a replacement switch that can change the fan from single speed to variable speed?
Anyone have any suggestions?
AC dimmers do not work.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.