Recent content by ofdjeff

This did help me a lot thank you. I have a 2008 3210 Cyclone and I have had nothing but issues with my single motor Venture landing gear. I want to upgrade it to a dual motor system and was looking at the Bulldog or Ultra-Fab setup for the increase in weight bearing/lifting capacity. But after...

Thank you so much for the quick and helpful replies. I was leaning towards the bad hydraulic cylinder, but thought I would post here at the experts. Thank you again. At jnbhobe, the picture that shows both slides out is after I turned on the power and opened the knobs, that was the result of...

I am hoping for a little help here. I have a 2008 Cyclone 3210. I have noticed that the living room slide will creep out while driving, and will also creep out once parked for storage. It only creeps out about 2-3" at the bottom, the top stays flush. After parking the 5th wheel in storage, I...

Know it's been awhile since the OP, but wanted to say Thank you. Thank you, this is just what I was looking for.

Thanks for the reply. So far it has been ok. Works good on spots where there isn't a lot of oxidation, but need something better on oxidation spots. Could be great on a well maintained finish, or between major cleanings.

Has anyone used Renew 3000 on their rig? If so, what were your results? Do you still use it? Would you recommend it? I have seen many of the posts regarding cleaning and waxing the rigs on this forum, but I have a bottle of this stuff from my old fifth wheel, which was aluminum. This is my...

Great idea about the kill switch.

This is great. Thank you for posting.

New to the forum and just wanted to say hello and let you know that this forum has been so helpful with the purchase of our new(to us at least) rig. Jeff