Recent content by Richard of Idaho

Man, now that is what I call service. I am going to go right out there and get-er-done. I saw that little plastic clip, but was kind of afraid to mess with it, for fear of breaking it, then I would have had another problem. So again, thanks a lot for your help. Richard of Idaho #1686

While on my last trip, after arriving home, I found that the pocket door near the kitchen of my 2009 3400RL Big Horn was off of track on the rear (inside the wall) roller. I can't seem to get it back on the track, does anyone have any ideas as to how I can get it fixed? We had some pretty...

I think that is what I will have to do too, put it in the truck. My only concern is that I have one of those tool boxs in the bed, but I think that I can fit it in between the hitch and the box in the center. The generator stands about two inches proud of the bed so I can't put it on the side...

I have used a small ramp with an indentation on the top for a tire to sit in. I just pull up the good tire onto it, and it lifts the bad one off the ground enough to replace the tire. I don't trust jacks. I have had to do this twice, and it works great. Richard of Idaho

Thanks a lot guys for the input. I see that I have a lot to think about. Thanks again. R o I

Maybe you could try using a stud finder that you use to find the studs with in the house. Won't work on a metal roof though. Just a suggestion. Richard of Idaho

I have a Honda 3000is generator. I want to install into the front of my BH 3400RL. It is prewired for a generator. I did notice that there is a galvanized junciton box labeled as a "Safe guard generator overcurrent protector". Does the generator hook to this box. I do have the controls...

I found that those 90 deg fittings put some strain on the fitting going into the rig. I use those quick disconnect fitting from Home Depot. They stay attached, and all you to is stick the male part of it in, no turning required, and very fast. Just a thought. Richard of Idaho

Thanks Ray, appreciate it. I guess that I will have to check out how to run a cable too.

Antenna switch location Being a little over 5-6, I had a heck of a time trying to find that switch for my TV antenna/cable. I found it in the back of the TV. There is no room to get you hand in to switch the antennas. I have to use a stick to push that little button. Is there any way to...

Hey, thanks a lot Jim, I went out and located it ok. Richard

Living in the NW and having to clear my water lines in the winter, I just know that someday I will not get all the water out of the water pump. I have a 2009 3400RL Big Horn, and would like to have someone tell me where the water pump is located, and difficulty in getting to it. Thanks

ultra lube axles I think that I have Ultra Lube axles on my 2009, 3400 Big Horn. Just what does that mean? Do I still have to have them lubed regularly, or is it already done for me? Richard of Idaho

I have a Big Horn, 3400, 2009. My question is, are the axles on this the never lube kind, or do I have to have the bearings packed. Thanks Richard of Idaho

Man.....thanks a lot...that does not sound so bad. I have heard that you had to unplug the motor (wherever that is located) and I could not find anyone at the dealership that actually knew where it was. I like your idea better. I am sure that she will be able to hold on .....at least till I...