Recent content by Thunderbolt

  1. T

    Cyclone 4270 tank draining

    In our 2018 Cyclone 4005, the front set of valve handles drain the gray water from the front bathroom and front black tank. The rear valve handles drain the rear black tank and the rear gray tank which holds water from the kitchen sink, the sink in the half bath in the garage. The black tank...
  2. T

    Rear Black Tank Material

    After speaking to Heartland Tech Services, I found the rear black tank on our 2018 Cyclone 4005 is made by Ameri-Kart, and is a model H865. Looking that up, I found it is made of polyethylene. I am going to cut an access hatch in the cloroplast to get to the tank and piping. I purchased a 1 X...
  3. T

    Rear Black Tank Material

    I have a 2018 Cyclone Model 4005 in which the rear black tank has started leaking. Since black tanks are made of many different materials, I need to know what the tank is made of to make repairs. The leak is somewhere under the corlpast underbelly. The water runs down the pipe then drips off...
  4. T

    Black Water Tank Knife Valve with Cable

    Could you please send me a picture or two of how you did this? I have a leak in the black tank which I feel is where the pipe joins the tank as the tank leaks down the pipe, drips on the ground and the tank is completely empty when the dripping stops. I have a jointer planer that i can run...
  5. T

    Satellite coaxal wiring from EDC goes nowhere

    I have basically the same problem. Factory wiring diagrams were not even close to the 2018 Cyclone 4005 we have. If you have the four connection satellite ports in your UDC, be aware two of them may go to a coil of wire under the roof for the addition of a roof satellite antenna. In ours, the...
  6. T

    Aiming Satellite SWiM dish

    How hard is it to aim the dish and what kind of apps are you all using? Going to the SWM technology so I have only one wire to deal with. May install a second set of wiring to allow us to continue to use the older automatic dish we have.
  7. T

    Installing RV satellite question....

    In the 2018 Cyclone 4005 the cable and satellite splitters are behind the speaker grill above the tv near the ceiling. I found them and now are trying to find where Heartland ran the cable from the UDC to the splitter area. I also am looking for the cable that is run to the external tv...
  8. T

    Satellite Cable Splitter Location

    Update: I found the satellite and cable/OA (off air) splitters. In our 2018 Cyclone 4005, they are behind the speaker grill above the television next to the ceiling. It is a mess to say the least. Still have not found the cable run to the outside television. Have some cables that appear to...
  9. T

    Satellite Cable Splitter Location

    Looked in all three cabinets above the television but there isn't a thin piece of wood in any corner and the back wall seems to be glued in place. Wish Heartland would put the splitters in an accessible location and tell the owners where they are. Thanks for answering.
  10. T

    Installing RV satellite question....

    Did you find where the splitter is located? Look for the one in the 2018 Cyclone 4005.
  11. T

    Satellite Cable Splitter Location

    Does anyone know where the splitter for satellite connection is located in a 2018 Cyclone 4005. We have the front compartment bulkhead removed and it is a spider web of cables. I need to find the splitter for the satellite system to remove it. Then I can tie homeruns into a multi switch to...
  12. T

    Just bought a new Cyclone 4005

    I am glad to see that you have the 4005. We have a 2018 model and the one thing that I would suggest you check is the amount of heat the furnace puts out in the living area. I am still working on that problem. We have tons of heat in the master bedroom but little in the living area. Also...
  13. T

    AWG WireSize on Batttery to Inverter

    *** Solved *** I made two cables and installed one circuit breaker. I made one cable to go from the battery to the 80 amp manual circuit breaker. I crimped the 5/16 inch lugs onto both end of the cable and used the supplied heat shrink tubing to seal them up. I mounted the 80 amp breaker and...
  14. T

    AWG WireSize on Batttery to Inverter

    Thank you! This answers the question. I will run 2 AWG wire from the battery to the hydraulic motor. And a 2 AWG white wire as the ground to keep everything even.
Top