Search results

Has anyone had problems while brining in the slide outs? Our bedroom slide comes in without any problems, but the living/dining room slides stops several times while brining the the side in to the travel position. Any trick fixes that anyone knows of?? Thanks, Butch:confused:

I have 2007 295RK and the pulls for the kitchen and black water valves now stay in the open position and I have to remove the under belly to hold the cable to close the valves. How is the cable held in the handle body, so I can open and close the valves? Thanks in advance for you help. Butch

I am having problems with the valve that controls the gray tank for the kitchen. The valve will not close. Does anyone recall how to adjust the valves so they work properly? I remember seeing some where but with the new pages I am unable to locate. Thanks for your help, Butch

I have a new tow vehicle and need to put new rails in the bed for the hitch. I have a Husky 16k hitch and noticed that husky now has an under the bed mount system so when the you take out the hitch there are no rails in the bed. Is any one using an under the bed rail system and if so how do...

I am seeing some buckling near the pin box and the fibergass is being warped. I went by Ray's RV in West Sacramento the windows are covered and it appears that they are out of the service business. Can you please recomend a Heartland dealer that will be willing to look into and repair if there...

As I was backing the trailer onto the pad next to the house Sharon stopped me and said it looks like the trailer is buckeling around the pin box area. I have heard about this problem but unable to find anything under "pin box" in the search mode. The trailer is an 06 2925RK Bighorn. Is any...

We are on the road headed for the Pacific Northwest while in the kitchen Sharon noticed a lump under the lino. It is near the base of the cabinet and feels like a nail or screw head. Do you have good suggestion on how to set the nail or screw without putting a hole in the lino? Thanks, Butch

Ok I may have lost my first attempt at this question. While getting the trailer ready for a trip I noticed that a trim piece in the bedroom is hanging down. Are these trim pieces glued or stapled into place? I did not see any staples but the ceiling tile feels like there could be staples. I...

Has anybody stayed near the park and if so what is the best access to get the best views? Any good RV parks near by? Thanks for the imput, Butch

We have the 29 RK and the oven is not working. The range tops works just fine. The unit is 3 years old. We used the oven only one time any Ideas??:confused: Thanks, Butch

It appears that my local Heartland dealer is on their way out. Ray's RV located West Sacramento, CA. I stopped by and the parts department and shop are closed for the next 30 days. Also there is a Large for sale sign near the entrance. If I need parts or someone to provide service to the RV...

Is ther a weight limit that can be put on the roof area to clean it? Thanks, Butch

I have noticed that when we are set up the trailer has some movement while walking around and increases when someone is up stairs in the bedroom/bathroom area. Is there a product that will decrease the movement of the trailer once it is setup? Thanks, Butch

We have a 2925 RK and would like to add a hitch receiver to our trailer. Is this possible and if so will it void the frame warranty? Thanks, Butch

I taking my trailer back again for repairs that have not been completed since I purchased my trailer in Devember of 2006. At this point Ray's RV is stating that Heartland is to balme for the slow response in providing the materials needed to make the necessary repairs to the trailer. Could...

Does anyone know the id size of the fresh water tank overflow hoses? I would like to install 1/4 turn valves so I do not lose water as I travel down the road. Thanks, Butch

Mr. Brady we took out trailer out for its first trip almost two weeks ago and have some more questions I hope you can answer. 1. Is it normal to be able to see outside between the door frame and the wall. I am able to see outside between the wall and door frame near the floor. 2. At the factory...

We were able to take our first trip in our 2925RK this past weekend and had a great time. What a difference between our toy hauler and this unit. We had a few little problems, I was unable to turn on the reading lamps over the bed, and neither side would work and ideas. Also, I was able to see...

I have been looking at campground memberships, but they seem to cost a lot of money. Have seen some on ebay TT/NACO. But most have a 14 day limit and you have to leave the park. Just looking for input. :o Thanks, Butch

Scott, I purchased a new 2925RK from Rays's RV in Cordilla, CA. During the PDI, which ws on 12-21-2006 we had 20 items that needed to be corrected. Their service center is located in West Sacramento, CA. I believe that the last four vin is 4240 ( Ray's could confirm). I contacted the...

Scott, yeasterday my wife and I did the walk-through to take delivery of our new 2925 Bighorn. While on a creeper underneath the trailer I discovered water causing the coragted material that encloses the undercarriage to sage, and could move the water around by pushing on the material. The...

Does anybody have a good insurance company they can recomend. I have received bids from $400 to $2,000 per year. I hope to find a balance of price and service. I had Foremost before but never had a claim, but they rather pricy. Gmac is resonalbe but I do not know if they will service their...

Are there work sheets to help determine what size generator one will need. Also, looking through the owners manuel I am having a hard time determining what the draw is for the appliances?? Any suggestions

Has anyone installed a Honda water cooled generator on their trailer? If so how difficult was the instalation?

We will be taking delivery of our 2925RK in a few weeks. I will be using a form I found here, and it looks like the inspection will take several hours to complete. To do a complete inspection have others removed the panles that cover the underneath side of the trailer? and if so are the screws...

I an buying a 2925rk and would like to put in a LP Genrator. Are the units Generator ready? If not how difficult is it to install a Generator??:confused: