Search results

Finally got back inside the underbelly, been on the road moving a bit lately. Yes the check valve (cheap black plastic piece) did have some calcium rocks inside, probably from the last flush I did. Knocked the rocks out and it seems to be operating freely at this time. I put it back in for now...

Thank you. I will have to check that out. Hopefully that's it and I can get this issue solved. Gotta keep the wife happy. ;)

UPDATE TO SITUATION: Well it's happening still. I went and bought two new check valves to replace on both the cold water intake and hot water output. I disconnected the hoses and found the "check valves" to be glued in place. So I though, let me check out the valves quickly before trying to...

Thanks Danemayer, I'll have to give it a try next time it decides to just quit again. Maybe I'll be able to feel it when it pops back on again because we can hear the clunk pretty good up in the bathroom.

Hello everyone, I need some assistance. I have read through many posts in this forum regarding this issue but still have a couple questions I hope you can help me with. First, my situation... I have a 2017 Cyclone 4114 with an Atwood 10 Gal hot water heater (Model GC10A-4E). I have an...

Well, that was it. Even though the test and reset was working (popping and resetting) it wasn't allowing power through. Replaced the main GFCI plug/switch and everything is working great. Switch just went bad.

Sorry for the delay in the pictures. I'm new on the forum and the system wouldn't allow me to post pictures until after I have posted a few times.

Thank you for your input. I troubleshot the voltage and I have 120 coming into the plug but nothing coming out. The GFCI seems to be working properly as it trips when I push the test button and the reset clicks back in to place afterwards but the green light does not come on. I'm going to try...

Had my GFCI lose power last night. All GFCI outlets in my rig are out of service. I checked the main outlet in the bathroom, tested and reset just fine, still nothing. All fuses and circuit breakers are set. I even powered down everything, tripped all the breakers and reset them, pulled all...

I've had two axle mounts break on the rear axle of my triple axle toyhauler. I'm not over loaded as I only have one harley and two chairs in the garage. The issue seems to be that the hangers are 5 inches long v. a normal 2-3 inch bracket. The first one broke on one side and I was able to get it...