Search results

Welcome Bob and Sheri. Have a great time with it and we are looking forward to hearing about your outings.

Thanks guys. I double checked the tv area in the bedroom, no luck, just 2 cable outlets, phone outlet and 2 ac outlets. Big G, Yall have fun at Sturgis, maybe we'll cross paths some where around Yellostone.

Well I looked all over the unit and did not see it. Did a forum search for 'dc outlet location' no help there. There is a fuse for it on the DC panel. Help! We're headed up to Ocean Shores Wa for the bike rally on Monday. Maybe we'll see some heartlands up there. Then over to Glaicer NP...

You guys hit it right on the head. I will have to try and remember to do searches on here in the future. Ours is working now.

Had doubts about our water capacity after our first outing. Water pump started sucking air on the second night. According to the test panel I had filled it to 2/3'rds full. Should nave been about 70 gallons as the unit is supposed to hold 105 gallons fresh water. Drained the low point...

3 out of 4 were working. The defective one had most of the wires inside the hub fried. Looks like they rubbed against the drum and shorted out. We are getting ready to head out for our second outing (Approximately 900 miles this time) with the 3110DS. After our first outing into the desert, at...

Hi guys, Thanks for your information. I will check under there. Sounds like your problem was a whole lot worse than ours. We're heading up the the nortwest corner of Nevada on the Th June for some rock hounding and gold prospecting. Any tips or hot places to go? Best regards, Buddy

We were unhappy with the way the carpet was not trimmed correctly and a half inch was stuffed up the end of the wall between the end of the wall and the trim. Also stuffed up in there was some folded over rubber material that is used as a seal between the slide out and the rubber gasket on the...

The wood that slides on the floor when the slide out goes in or out tore our lino. Ironically it tore it just a fraction of an inch before the slide out tips up and the wood comes off the floor. The bottom on the wood is not tapered. The top is tapered to prevent you stubbing your toes...

The factory told me to take it to one of their dealers of my choice and they would coordinate with them to resolve my issues. I think that was great of them and I appreciate their support and prompt reply. They regretted me having these issues with the unit and said that is why the warranties...

Thanks Jim. Here is a link to the photos. They show a few issues. http://good-times.webshots.com/album/563509979WXBaIs 1. The rear of the larger slide does not close all the way and the fender halfs don't line up. However the decals are lined up. 2. On both of the walls on the larger...

Floor slide Jim, thanks for forwarding the message to the factory. Jim Fenner replied and I replied back on the floor issue and other things we have discovered. Forest, I do have photos and I do appreciate your offer of help. However since I am in correspondence with Jim Fenner at the...

So my question is. Is the tapered edge of the black piece of wood that slides on the carpet and then the floor susposed to face the ceiling or the floor. Mine faces the ceiling and therefore there is a sharp corner of wood that slides on the floor verses a smoth taper. We took it by the...

Check your nose cone for cracks. See my thread for photos. Even though mine is a 3610. I'm still waiting for a reply from the factory, again see my thread. 5 out of 6 corners I checked were cracked. That was on 3 different Razors.

Moderators, I hope you approve this. Edited by Admin... Buddy - I emailed your observations and your concerns about Razor nose cone cracks to the factory. I have edited out your questions to other owners from this thread as the ATF forum is not for conversations. Thanks - Jim Thanks...

Well, I didn't get into the compartment today. spent the day taking off the tie downs from the truck to go with the tc which is for sale. The adapter at the local rv parts store was 72 bucks. So now I'm checking out what I have and a way to get it done a lot cheaper than that. I doubt I'll...

Thanks guys! In the next few days, I'm going to remove the access cover and see what kind of battery charger it has and I am going to buy a 50 amp to 15 amp adapter so I can plug in at the house with a light weight cord. Will only use very light current draw items in that case. Mainly lights...

Well we closed the deal today. They delivered it about 1330 today. Thanks for your emails nvtahoe, they helped us decide to go ahead and get it.

LK, No problem on the forum's policy. I will call the manufacturer on Monday and find out what is happening msrp wise. The dealer here also said the steel wheels on the unit is Heartland's idea of aluminum cast wheels so I am going to check with them on that also. Plus I also heard that...

Cool, is there a forum where it is allowed.

Hi everyone, We just put down 1,000 to hold a 2008 Razor 3110DS with 5.5 gen fuel cell 2 queen beds in garage 15kbtu ac awning rear screen all for an out the door price of ****** Let me know if you think I am getting ripped off or getting a really good deal or just a regular deal. :rolleyes...