Search results

Thanks again. Yes, will have to try a couple of different string paths from examples on the web. First attempt, string (which I cut 12 inches longer than the original), was too short. Another attempt soon with a different path, thanks again.

Thanks for the reply. Does it matter the stringing pattern given these refer to a middle spring in the top rail, but my top rail has the springs attached to each the end caps.

Wondering if anyone knows what brand of day night shade was standard in a 2012 Landmark Mesa. I have a 4 String day night shade that the string broke, and all the info I find on restringing have springs in the middle, but mine are attached to the end caps on each side, so not sure the path way...

Thanks again.

Thank you for your rapid response!!! There is a 9/16" rubber piece for the one you used that mine does not have, don't think it will matter for my install, and I can trim it off if need be. Thank you once again for your assistance!

I have a 2012 Landmark Mesa that the vertical bedroom slide wiper gaskets sound the same as yours. With mine, I have to access from inside with the bedroom slide in, and the wiper slides into the metal channel from the top (no adhesive tape at all). The wiper rubber is 1.5" wide and the track...

Thanks to everyone for your assistance and suggestions. End result was a new controller board was needed.

Thank you for the reply. Yes, I'm, on 50Amp shore power with 2 full charged batteries.

Thanks for the reply so fast. Learned something new. Will pop onto the roof and see if I can find the comm cable at the AC unit (my AC is ducted returns if I'm understanding you, I don't have the large square area that I had in my old unit, that had the air return and filter in it).

I finally was able to open up our 2012 Mesa last weekend and ran into a Dometic CCC2 issue. The main Dometic CCC controller for the kitchen / living room had an E1 error and only shows Cooling, Fan and Off, where the CCC in the bedroom shows Cooling, Furnace, Fan, and off (and no E1 error). I...

Thanks Bob, found the pictures in this really long thread that should help me just fine. The challenge is now i want to do a manifold setup as well lol!!!

Thank you, any assistance is greatly appreciated.

Correct. There are 3 connections to the bypass value. Trying to figure out which line runs to which end point as who ever took out the bypass joined the lines together and have a reverse osmosis system tied in. Any pictures would be greatly appreciated.

Thank you for your willingness to assist, very much appreciated! No rush, I'm in Canada and the unit is stored for the winter. I'm just planning for next season.

For reasons unknown, the previous owner of our 2012 Mesa removed the hot water bypass valve, possibly because of installation of reverse osmosis system installed. I have a new JR Products bypass valve, but wondering if anyone has a picture of which line went where so I can try to figure out how...

Correct, whomever installed the reverse osmosis system removed the 3 way valve from the UDC. Trying to figure out why, and reinstall.

Was looking for the blind manufacturer specifically, and the plumbing design as the hot water bypass was removed when a reverse osmosis system was put in.

Thanks for the information, most appreciated. Have a couple of items to fix on 'new to us' Mesa so trying to gather documentation I haven't found yet.

Anyone have a copy of the 2012 Landmark Mesa owners manual they could share? I see manuals for 2011, then 2013 forward, but no 2012.