Search results

On a 2010 M22, how do I gain access to the water connections for the outside shower. These connections must be located in the bottom of the closet between the bunks and bathroom. From the water heater compartment there is no apparent access to the connections. I can see the water lines passing...

I've recently taken my 2010 M22 out on its first few trips. I am noticing bits of what appears to be sawdust appearing on the counter surfaces and in most of the cabinets. I'm guessing that this is normal as the cabinets settle in while getting flexed running down the road. Is this to be...

I've put around a 1,000 miles on my 2010 M22 now. Over the last few trips, I've found it necessary to keep reducing the maximum voltage on my brake controller. It seems as if the brakes are exerting more stopping force with less voltage applied. I have a Tekonsha Prodigy P3 controller. I've had...

It would be nice if the shower curtain was held out about halfway down the curtain. This would effectively increase the size of the shower without taking any more floor space. I suppose you would have to also add something at the base of the shower curtain to keep it inside the basin. Perhaps...

In our 2010 M22 after every shower there are little puddles of water along the wall outside the shower. This is coming from water running down the walls onto the raised edge of the floor piece and then running over the sides. There isn't really anything to force water to drain into the basin...

I love the lighting you put in above the cabinets in the M22. It's a nice night light to get up and manage during the night without blinding everyone. Unfortunately the times when it's actually dark enough for me to need a night light, it's generally too cold to use my trailer! :) So now for...

I love my 2010 M22, but the shore power connector is one of the few things I generally don't like about the unit. A few questions and some design feedback as follows. 2010 M22, my shore power connector has a twist lock connector with a threaded plastic ring on the connector. It is difficult for...

I noticed a draft coming from the vicinity of the fridge. When I bent down to look for it, I can see light from outside from under the fridge. There is a gap on the bottom side of the fridge that is not sealed. It is a bit more than 3/8" and is present the length of the fridge. Is this gap...

It would be nice if there was a good storage position for the table top. It's fairly heavy and I don't want it sliding around inside the unit. I don't want to just lay it on the floor, I'm afraid it will become scratched up. My current solution is to put it on the bottom bunk and place the top...

The rooftop unit in our M22 has a 'heat' position on the control. When in the heat position the air never warms up. Also, the unit pulls about 400W from my generator both in 'fan' and 'heat' position. Is the heat element not installed in the rooftop unit on M22s? Is it possible to acquire one...

It would be nice if the M22 pump had a hinged access door as opposed to removing and driving screws to access the pump. As is, it is only going to take a few winters of removing and reinstalling the screws to wear out the holes. Thanks for installation of the winterization kit from the factory...