Have you thought about buying a scan tool from harbor freight? when I had issues while traveling I was able to pull over clear the code and go on my way. No way of predicting if that code can be cleared by their scanners. But for under $100 might be worth a try.
When I had issues with the A/C I ran a new 12 volt line to the thermostat and have no problems since. As the whole system is on the same 12 volts it does not seem to hurt anything
I carry a full wheel bearing and race set for one wheel and the minimal tools to replace it. Even if you cannot do that work having the bearing set can cut down on repair times.
If you have the room with the jacks retracted why not just attach the blocks to the pads on the front legs. My pads have holes in them already. it would only take a few minutes to unscrew the pads to travel. would seem to be a lot less work
I recently lost a foot pad while on the road, contacted Lippert they say that they are Loctited in place. they were kind enough to replace at no charge just pay for shipping.
we were at Branson KOA very narrow sites, PLUS the do not tell you when you reserve that you might need leveling blocks. It was over 22 inches to my first step!!!! Yes almost two feet.
sorry about side ways picture, yes you can see some water damage from 'leaking roof corner?' not sure exactly where but look at the aluminum channel how it has bent, poor weld and what appears to be a tear in it. Cost was about $2000. to have is all repaired. Hope this helps
- - - Updated -...
I have come across a similar issue and it was broken welds within the wall. See if you can pry the seam open and shine a strong light inside to see what is going on
Be careful in which bottle jacks you purchase. some are labeled not to be used to support for any amount of time. I found that mine leak down within 48 hours.
Right now I am trying to bleed out the water by connecting an air tank at about 30psi to the drain line under the slide. I hope to have the ice maker cycle through and automatically blow air into the lines and thereby clean out solenoid and other lines.
One of two ways you might be able to fix is remove inside or outside covers, make sure power is off first, then try turning the fan by hand. I have had this happen before and then just spray a little lubricant on the fan shaft if you can see it. the lube they use hardens up stopping rotation.
My 2011 Greystone has exactly the same problem as in the picture. Was 'fixed' by the dealer under warranty. Went to Goshen Rally where it was "fixed" again by factory techs. they told us there is a 2x2 in the aluminum tube that is screwed to the assembly and that it splits from too many...
Only mentioned it since one of the earlier posts talked about low fluid might be an issue. Lines that run to trans cooler. He might not know that the leak as there.
A number of the GPS devices out there will keep track of these items for you. The Rand Mcnally will also track fuel usage but you have to enter the data. It is amazing to see at the end of a multi day trip how slow you may have traveled.
Thanks for the idea Jim however the panel is smaller than the wall is. In the dark I could not see that when I started. I actually cut the panel in half, moved one side back about six inches and left the other where it was since it was connected to the UDC.
I would not recommend using dry ice in a sealed fridge. In a cooler the gas has room to leak out. in your fridge as the pressure builds up there is a chance to have the door 'blow' open and contents spill out. Also if you do use it be extremely careful it is cold!!
Mine in our Greystone has done the same. There is about a 5" opening under the drain that is unsupported. I used eternabond roof tape to fix about a month ago. Not pretty but seems to be holding up
If it is the motor I believe that there is a post about using a car window motor that is a replacement and about $50. sorry but do not remember the thread
We have a 2011 32rl and it was prewired for second AC. Bought Dometic unit from CW on sale with $39 install. only problem is unit is noisy. Good to help cool camper in the day time but turn it off at night so we can sleep.
Hi Tony, We will be in the area in early July Hope to see you there. We met at the 2012 Wyoming rally Two couples from NJ, actually there were four couples at the campground.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.