The light is powered through a relay on the back of the refrigerator. The relay power goes through a blade type fuse on the back of the refrigerator.The interior light in my RM1350MIM does not work. I have checked fuses and replaced the bulb, which was not burned out. Where do I go next?
Had an issue with closet lights on my BH. Turned out that a 12V wire clip had come off on the back of one of the fuses. Had to pull the fuse panel off wall and replace loose wire after tightening the female clip with pliers.
The light is powered through a relay on the back of the refrigerator. The relay power goes through a blade type fuse on the back of the refrigerator.
Wiring diagram with markup is attached.
Dan:
The way I read that schematic, power (+12 v) from the circuit board comes on wire #1 to the lamp, goes through the lamp to the switch, and the bottom of the switch is tied to the common ground point (12 volt return) through wire #3. This is all of the lamp circuit.
The nearby relay is not involved in the lamp circuit. The relay switches a 120 volt water solenoid that seems to be involved in the icemaker.
Best Regards,
I have re-checked all 3 fuses. They are all tight and not burned out. I doubt that both door switches would go out at the same time so will look for something else.