hydraulic

So been a while, camper has been amazing. Multi point question. How do you remove the the under cover, that is part of the winter package. I have a small hole in it in the center ( i did not put there) where hydraulic oil is leaking. it has leaked quite a bit of oil over the winter. I see...

When I push the slide out rocker switch to in to retract a slide out my landing gear retracts. My landing gear extend and retract button works fine. The unit has been without power for a month. I plugged in my 50 amp 5 hours before I tried to retract the slide outs to charge the battery. Is it...

I need some input on what to do this situation. My wife and I just bought and picked up this 5th well from Wade's RV in Glenpool, Ok near Tulsa. We towed it home yesterday (4+ hours). During the walk-through, the tech had some problems getting the slides and the auto leveling to complete. He...

I noticed a small puddle of fluid between my refrigerator and pantry door last night and when I went to wipe it up, I realized that it wasn't water. It is slightly oily, although it has no color or odor and not super slick... just kind of oily or maybe slightly sticky? The area of the floor...

I have a Big Country 3450 and the dining room slide stops several times moving in and out. The slide will stop, I will wait for 5 seconds then push the button again, the slide will move about a foot before stopping again. this will happen several times on each cycle. they are hydraulic slides...

If you have had your hydraulic system upgraded for landing gear or level up, check all connections for leaks a day of so after the installation. I discovered a minor fitting leak after I had new landing gear installed. The best way I found to confirm there is a leak, is to clean the suspected...

Last week (Wednesday) on the way to the Nashville Rally, we had Level Up installed on our Cyclone in Goshen by Trailair. We then proceeded to Nashville and the system worked great. On the way home (Sunday), we stopped for the night and found the system inoperable. Shortly there after, we...

I have posted 2 PDF files in HOM (Heartland Owners Manuals) for the optional Lippert Electra-Hydraulic Leveling system for Landmark. One of these documents contains pictures of the control panel. Note that these images and sequences may not match up with earlier versions of this system. Jim

About three weeks ago after having new Michelin XPS ribs and some other warranty work done at Camping World in Katy. They did a great job. Once I was at my storage facility the landing gear quit working. Since I have ultra fab leveling system I was able to unhook. I contacted Heartland and...

Is the Landmark the only Heartland unit that has the hydraulic land gear? I keep reading the stories of "my landing gear when pop" and "the gears won't turn" and "the motor case broke." I think it would make since to at least offer the hydraulic landing gear as an option, if not make it...

While doing a little system checking today I discovered a little issue with the mounting plate for the hydraulic (slide) pump on the 3610RE. The pump assembly is mounted on an aluminum plate attached to the framing with self-tapping metal screws. I found that there were only two screws...

What are the hose connections on the hydraulic system. What is the Hydraulic schematics for installation isolation valves to move sides individualy at selected sequence, or is it better to install flow regulator to open slides selectively. I plan to install 12DC solenoid valves to isolate at...

anyone installed hydraulic isolation valves to permit individual slides to open. I am realy having a problem with not controling individual slides opening. The slide I want to open mostly, opens last. Is there a hydraulic dia. available

I have a 2006 Landmark Shenendoah. Because the fittings are leaking going to the slideouts I need to relace the hydraulic lines. More Chinese crap:mad:. Since I'll have to drop the bottom to access the lines I've decided to replace all the lines. I have three front jack lines leaking also...

I had to take the plywood off my bed to search for something underneath (no comments now!), anyway I had to take those little black hydraulic lift arms off. Now they have fully extended and I can't get them to move so they can be re-installed. For now there is no rush to fix them but I would...

Are there "limits" on the slide extension? Either physical or electrical. What "makes the slide stop when extending it out?

Whats the procedure to deal with the loss of hydraluic pressure on the slides. Wondering in particular if a manual method might get the slides in? And will it actually work..

I have a 06' Landmark. I have had several problems with the hydraulic hoses leaking. They don't leak at the fitting but at the junction where the end fitting is crimped onto the hose. I have replaced four hoses only to have the new ones leak. They were purcased from Lippert. The only hoses to...

I like to live dangerously I guess because I have not found out how to retract or extend any of the hydraulically assisted systems on our Landmark. I meant to ask but it took a year! Anyway, I saw where someone said there was an existing system to use a drill to operate the pump if something...

I just noticed a small amount of transmission fluid on the battery case beneath the slide reservoir, but I can't see an obvious leak. It might become readily apparent during operation of the slides. The reservoir is just less than half full. The owners manual said I could check the level by...

This weekend as we started our camping experience I noticed the Kitchen Slide on my 3670 did not operate in its normal order. It has always been the second slide to move, this time it did not operate until the other 3 slides were out. Whne I retracted the slides the kitchen was again lagging...

I just found the hydraulic cylinder that operates the slide in our bedroom leaking. The cylinder has a pin hole in the side of it at the point of where the upper (closest to the rod) hydraulic line attaches. When the slide goes out the pressure increases and the fluid squirts out the pin hole...

Have noticed the hydraulic pump, Lippert, is drawing about 40 to 60 amps. for the slides. What is normal? Does Lippert have a website for information? Bob

After spending the weekend with a friend and their new Titanium, we are wondering about changing our electric front jacks to hydraulic. Has anyone else done this or thought about it? Seems to be not a tough thing to do, but wondering if we need to get a bigger pump and reservoir or would the...

Hello heartland people, Can you tell me :confused:what braking system are on the Cyclones? Are they electric or electric over Hydraulic. I'm asking this as I've read issues with Chevy & Ford trucks that have the intergrated brake controller(IBC). I just took deliveryNone on a new Silverado...

Can you please tell me which hydraulic fluid is the right type for the slide outs? This is our first time with that type of slide out and the manual doesn't mention which type is best. Thank you! Donna ;)