Got a 2011 Elkridge 5'er with electric Jack's upfront, last summer I moved the trailer a few times and each time even with the truck idling for extra juice through the 6pin (camper battery charges off truck) healthy deeo cycle in the trailer and even being plugged into shore power the Jack's...
I would like to add JT Strong arms to my travel trailer to eliminate the rocking of the trailer. My trailer's underbelly is fully enclosed. Does anyone have photos or suggestions on how you may have installed them on your trailer? Thanks!!
I have three issues with the level up. 1) at times using the front extend/retract switch connected to the truck and both middle and rear legs are fully retracted the front stops retracting. depress the button 5 or 6 times in either direction it then starts working again. 2) when getting ready to...
A year ago I was looking for tech support and a new remote for my touch audio system, but couldn't find anything published nor a universal remote...
just recently i found found what many others had been asking for and many may still need so I figured I'd post the info...
Lippert Components is...
We just bought a 2013 FLPS and compared to our 2007 Denali that we had it seems like it takes a long time for the jacks to raise the front of the RV. It also sounds like theres a lot of stress on it moving it up. Does anyone else have the same issue? Just trying to make sure that there isnt...
We are going to do our first seasonal site in a few weeks. We are wondering what we should use under the jacks for stabalizing and under tires. There is a gravel base. We have read where some people lift the camper off the ground with blocks. Brand new to seasonal so can use any advice you...
Does anyone have a picture of the electric rear jacks on their Bighorn? I am getting stabilizers for my trailer and I don't even know what they look like. I pick my 3055 up in the spring.
Thanks
Rick
I am curious if the rumour is true that all 2011 models will have a hydraulic front landing gear? If this is true, good work by Heartland to fix a major issue on the Cyclones.
As for me, I would like to know if Heartland can offer a retofit kit that will allow me to install this system on my...
My jacks were on 4 inch box tubing. I removed the box tubing to allow the jacks to be completely recessed. I discovered this after nearly getting stuck because the jacks sat way too low. Naturally this means the jacks could have been ripped out as well. They were originally welded in, but i...
I heard a clicking noise:confused: when raising my landing gear a few minutes ago. Took a look and the nut had come off the screw that holds the shaft that turns the gears that raise the front jacks (whew, thats a mouthfull:rolleyes:). The screw had backed out about half way and was hitting...
I have been looking real hard at buying a tongue jack. The ole back has had two surgeries and the crankin on the manual jack has got to come to an end. I have been looking at many remans on Ebay. Came across the Odyssey 3000lbs electric jack that is a reman but with a 3 year warranty. My...
We left the campground today, but while raising the front jacks I noticed that as they were just about all the way up they stopped. They would not work any more. The rig is loaded on the truck so we got home o.k., but I can't get the rig off the truck. I am calling the dealer tomorrow so...
I'm a new BH owner and I have a question. My BH 3385 has electric rear jacks which I really like but my question is: If I put leveling boards under the wheels on one side do I need to put the same size board under the jack on that side, or will the jacks compensate for one side being higher...
We have a 2010 Landmark Augusta. We were releveling it this evening & the front jacks stopped working. They are fully extended. There is no motor noise at all now. Is there a fuse somewhere, or something else we can check?
Thank you for any & all help.
Just back from first trip 2800rls got to yellowstone park and wanted to remove trailer from truck and the jacks failed. the motor runs the cross shaft turns both shafts on the jacks the jacks are not loose. we dropped the jacks and they supported the trailer so we could spend 2 days in the park...
Just wanted everyone know about an issue I just experienced with my new 2010 3055RL. I was retracting the front landing legs and might have had the switch in too long. Well now both legs are now broken. I’ve dropped the motor side leg and took out the gears in the top. There is a horizontal...
I was able to remove the cover to the doorside front jack and lube it but I can not figure out how to get to the streetside jack to do it. Has somebody figured this out and lube it?
While working yesterday getting our playhouse ready for a trip at Easter,I remembered that on our first trip last season the rear stablizer jacks did not want to move when I hit the button. I could hear the motor click and try to move but I had to bump the switch a few times and hit the motor...
Has anyone had the front jacks motor go bad? Mine lets out a little groan and quits when trying to raise. I did see sparks fly out of the front of the motor. It will lower tho. Cranking it up by hand really sucks. Is it easily replaced?
We are currently wintering in Yuma after travelling across Canada from BC to Nova Scotia and then down through the eastern US and across the south. During our 10000 mile journey, our '09 Big Horn has performed well for us except for the usual problems that beset all RVs from time to time.
We...
After spending the weekend with a friend and their new Titanium, we are wondering about changing our electric front jacks to hydraulic.
Has anyone else done this or thought about it? Seems to be not a tough thing to do, but wondering if we need to get a bigger pump and reservoir or would the...
I have been having trouble with the electric rear jacks on my 09/2900mk. I am pretty sure it is a switch issue especially since it gets soaked from wheel spray. I took a look at the manual raising screw and realized that the 2 wrenches supplied with the trailer would not work. Am I missing a...
I am hoping that someone can help me find a motor for my rear stabilizer jack. Coming out of a RV Resort that had a steep driveway the motor hit the ground and broke in half. My RV Repair Shop can only find the entire Rear Stabilizer and Jack setup. I don't need the entire stabilizer just the...
My Front Landing Jacks Groaned And Would Usually Pop The Breaker Two Or Three Times When Lifting The Unit. I Had An Electrictian Measure The Amperage And The Motor (fused At 30 Amps) Was Pulling 42 Amps. I Contacted The Dealer And They Talked To The Factory Which Sent Out A Larger Motor. This...
My 3950 grunts and groans and usually popped the circuit breaker fuse if lifting a foot or so. I installed a resetting type of circuit breaker and that has helped but it will still pop it if lifting very far. Is this normal? Could I put a heavier fuse going to say a 30 amp vs. the 20 amp that...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.