2009 3300bhs landing landing gear fuse location

Hockey55

Member
Just bought 2009 3300BHS and used the landing gear twice. Went to use gear and no movement.
Hooked up power to motor direct and it works .. Where in the heck is the fuse located ??? May be switch but need to eliminate the fuse .. Any help would be appreciated ..
 

cookie

Administrator
Staff member
Hello Hockey55 and welcome to the forum.
Take a look at the back of your landing gear switch.
Look for a pink wire. Follow that.
The fuse may be in that wire.
HERE is a link to Venture landing gear manuals and other stuff. This was found in Tools at the top of the page along with a lot of other great guides, manuals and other troubleshooting guides.

Peace
Dave
 

Bob&Patty

Founders of SoCal Chapter
Do as Dave suggested. If the fuse is blown...go an auto parts store and buy a 50amp circuit breaker and install it....not a fuse. Take the fuse with you so you get the right size circuit breaker. Next, make sure that you are not running the landing gear all the way up while still holding the switch. That will blow the fuse everytime. When you get it working again....run it down about 3-4" and use something to mark that spot.....paint, magic marker...something that wont wash off. Never run it up past that mark again. Also, good battery voltage is a must unless you are connected to your TV (running) or shore power. My 5cts. (inflation)
 
i also have a2009 3300 toy hauler and the fuse is right behind the battery in a rubber case you have to take the top of the case off and the fuse will be in it the question that i have to ask is does anyone know what size the fuse is as i have read on the forum that it is 30 amp and 40 amp and now they are saying to go get a 50 breaker what size is this thing i have replaced the drive mech and motor and casing HELP
 
Top