Bottom of the slide out floor gouged

[cyclone4007]

So the bottom of out slide out is gouged through the plastic into the wood. This is on a 2019 Cyclone 4007 that we purchased in May 2019 so still has warranty but sick of taking back for warranty unless I need too. I can't see how it is getting gouged looking at everything, no rollers just a big plastic bar.

 

[cookie]

When the slide is out, bring it in a few inches then check that plastic bar looking from the inside as well as the outside.
You might have a screw backing out or some debris stuck on that bar.

Peace
Dave

 

[cyclone4007]

When the slide is out, bring it in a few inches then check that plastic bar looking from the inside as well as the outside.
You might have a screw backing out or some debris stuck on that bar.

Peace
Dave

I did that and I used my inspection camera and see nothing, if I was a little handier I would post a picture but pretty new to this forum and don't have that figured out yet. Sorry

 

[cyclone4007]

Thank you Dave,
I did do that and I took my inspection camera and everything looks good. I would post a picture but new to the site and don't quite have that down yet, I'll keep working on that so you can see what I'm trying to say.

Thank you
RonD

 

[donr827]

I believe that you need 3 post before you are allowed to post pictures.

 

[lynndiwagoner]

I had two slides doing the same thing....crawled under and adjusted the offending side upwards about 1/2 inch. It's really relatively easy to raise the entire slide on the rack.

 

[Dmetcalf]

We have a 2019 - 4007 and our dbl. slide has 3 - rollers on the smaller slide and 4 - rollers on the larger slide. No indication of any damage to the underside. We purchased ours in Jan. And have used it 7 times including this weekend right now. That could be a labor intensive repair I would think. I’m sorry to hear that your unit is out of adjustment..! Hope you get this resolved..!

 

[cyclone4007]

I believe that you need 3 post before you are allowed to post pictures.

Must of cleared the photo hurdles but here it goes I think. I guess not still no photos allowed!!