We're going to place a custom Cyclone order.
I know the Cyclones comes with Rear camera prep. We would like to however instead have a Ford Super Duty (F350) trailer camera installed – i.e. this kit:
https://accessories.ford.com/exterior/trailer-towing/kit-tpms-sensor-11804.html
This is a hard-wired system (not wireless), with wiring that has to run through the RV and then plug into the back of the truck in a 15-pin connector together with the standard electrical hookup.
Of course I don’t want there to be external wires sticking out - however I would think the standard rear prep is for wireless so it may not an equivalent conductor wire installed by default? The important thing is that I don’t want it to look “after market” with loose wires running in visible locations.
Would this be something that Heartland can install for me on a custom order if I send a camera kit through to them before the build starts? Or can a dealer actually pull through a camera wire without it looking too bad?
I know the Cyclones comes with Rear camera prep. We would like to however instead have a Ford Super Duty (F350) trailer camera installed – i.e. this kit:
https://accessories.ford.com/exterior/trailer-towing/kit-tpms-sensor-11804.html
This is a hard-wired system (not wireless), with wiring that has to run through the RV and then plug into the back of the truck in a 15-pin connector together with the standard electrical hookup.
Of course I don’t want there to be external wires sticking out - however I would think the standard rear prep is for wireless so it may not an equivalent conductor wire installed by default? The important thing is that I don’t want it to look “after market” with loose wires running in visible locations.
Would this be something that Heartland can install for me on a custom order if I send a camera kit through to them before the build starts? Or can a dealer actually pull through a camera wire without it looking too bad?