I read in the manual about the "heat sensor" which I assume is like the old thermocoupler on old pilot light units, it did state that this may need to be adjusted to point more into the flame so it senses the heat from the burner. What the furnace is doing is after it lights the first time it burns for quite sometime then it starts this intermitent stuff. When the burner goes out you can hear the burner get louder and then a loud "poof" sound and it cuts off. It then waits a few seconds and re-lights the burner but now the burner only stays lit for 25 to 30 seconds then the loud burn and "poof" again and it repeats the process. I would assume this "heat sensor" is down inside the burn chamber near the igniter. As to changing the gas bottle the furnace has done this on both bottles, but one bottle emptied this weekend so I'm going to take it and have it filled and give it a test.
My greatest frustration is not being able to find an RV tech who seems to understand these furnace problems, everyone I have talked with doesn't seem to know much more than I do. I'm pretty handy but I really don't like working on stuff that I don't fully understand how all the systems are suppose to work. However, if all they are going to do is replace parts until they stumble onto the problem (if ever) well as I said before I can do that.
Today I plan as I said change the gas bottle, change the regulator, purge the lines from the bottles to the regulator, and then remove the furnace once again and go in thru the access panel to the igniter and check out the position of the "heat sensor". I'll let y'all know what happens, thanks for all of your suggestions.
Ron