left side slider not being flush with the unit

[LVINONTHEEDGE]

Hi! We bought our 2017 Edge 386 in Aug of 2017. We took it out a few times, but just noticed on our last trip the big slider with
the couch when it's shut doesn't shut all the way so it's flush with the outside wall. Is this normal. You can tell when you look around
the wheel plastic at the bottom. It sticks out about an inch. The dealer said it's normal and as long as the slider seals, there's
nothing wrong. It doesn't look like it shuts right. The bedroom slider is fine. Please help

Thank You

LIVINONTHEEDGE

 

[jerryjay11]

Personally I would prefer my slide to be flush on front and back thus I insisted my dealer do so when I noticed the gap. It isn't a big deal for the dealer to adjust and it makes since to do it before something happens, like water getting in and the dealer says, whoops. I'd tell the dealer to adjust so it fits like the bedroom slider. Since it is under warranty why wait until you have to pay?

 

[Gary521]

No, its not normal. The adjustment is fairly simple and just takes a few minutes to accomplish this. Make sure that there is nothing on the inside stopping the inward movement. Your dealer just does not want to do this. The adjustment is at the end of the slide hydraulic ram.

 

[TravelTiger]

Can you post a picture? Sometimes what we think should be flush cannot be achieved on an rv. We've had 3 different rigs, with varying amounts of slideout "flushness". It may be fine. Take a pic of the bedroom slide and the one you think is an issue and post back. You'll get more specific/accurate comments then.


Sent from my iPhone using Tapatalk