No Port For Solar On The Side

BigHorns

Active Member
We're in our third month in our 2019 Bighorn 3925MLP 5W. It has the GoPower Solar On The Side sticker on the side but the actual port to plug in has been completely illusive. Everything I have read says this port should, literally, be on the side of the RV. It is nowhere to be found ANYWHERE. Can anyone point me to what I'm missing?​

 

Oregon_Camper

Well-known member
I remember another Heartland member having his GoPower "solar ready" question His was inside the RV, close to the heater. He had a sticker inside his RV that refers to installing the PVM Solar Controller inside the RV.

Capture.jpg
 

BigHorns

Active Member
I remember another Heartland member having his GoPower "solar ready" question His was inside the RV, close to the heater. He had a sticker inside his RV that refers to installing the PVM Solar Controller inside the RV.

Wow. Not sure I get that. But I have no such situation. I have the typical sticker on the right side front of the 5W indicating the port is installed. I also have a PWM Charge Controller showing 13.2 volts on it. Not sure what it's connected to if not the tiny little solar panel glued to the roof. But no port for the Solar On The Side.

20191215_115028[1].jpg
 

cookie

Administrator
Staff member
The Solar on the Side sticker is a brand name sticker not a location.
The controller may only be wired for battery charge only.

Peace
Dave
 

danemayer

Well-known member
Earlier builds were pre-wired with lightweight wire for a small solar panel and I think the port was up front. Newer builds have a solar panel on the roof, wired to a controller that in turn provides some power to the batteries. It's a small, complete system. If you want to add to it, you probably have to add panels, put in heavier wiring, and get a larger controller.
 

Dmetcalf

Well-known member
Did you check out the roof to see if there already was a smaller 20a solar panel installed..? Our 2019 has the same sticker but I found a small solar panel installed on our roof. EC2468A9-A023-4AA9-8102-BB63C269158D.jpeg
 

LBR

Well-known member
Wow. Not sure I get that. But I have no such situation. I have the typical sticker on the right side front of the 5W indicating the port is installed. I also have a PWM Charge Controller showing 13.2 volts on it. Not sure what it's connected to if not the tiny little solar panel glued to the roof. But no port for the Solar On The Side.

View attachment 63454
Would love to hear back if you had resolved this yet?

You can add the plug on the side easily. The wires simply go directly to the battery circuitry with the + having a fuse.
 

BigHorns

Active Member
Did you check out the roof to see if there already was a smaller 20a solar panel installed..? Our 2019 has the same sticker but I found a small solar panel installed on our roof.

Yes, I do have a small panel on the roof- appears to literally be glued down. Sounds like you are confirming what I've suspected that it takes the place of a solar port on the side of the 5W- which eliminates the quick-connect for a larger portable solar panel.

What I'm also curious of is a 12V pigtail I have hanging loose in the battery bay ready to be connected to something. I'm hoping to have a chance soon to run that down and see if it's maybe solar-input related by any chance.

Thanks for your reply.

- - - Updated - - -

Would love to hear back if you had resolved this yet?

You can add the plug on the side easily. The wires simply go directly to the battery circuitry with the + having a fuse.

At this point, I'm resolved that the tiny solar panel on the roof has replaced the port on the side of the 5W. Kind of aggravating that I can't simply plug in my 120 watt portable panel as expected. The sticker is completely mis-representing. But- it's easy to rectify as you note. I'll probably add the port.
 

Dmetcalf

Well-known member
I too have a pigtail that is not connected to anything in the front compartment..? Maybe some one here knows more about this ..?
 

BigHorns

Active Member
A picture would help.

Here ya go...

And that's not lightweight wiring either. Pretty hefty stuff.

20191231_112552.jpg20191231_112547.jpg

- - - Updated - - -

And here's a pic of the little charge controller in the bay. About the same gauge wire as that empty pigtail. Makes me wonder. This controller is obviously attached to the tiny panel on the roof- I assume. But I still wonder if that pigtail is somehow connected. Hoping I can get down there today and trace it.
20191215_112939.jpg
 

danemayer

Well-known member
Use a volt meter to see if there's 12V DC on those wires. If so, turn the battery disconnect OFF. If you still have 12V there, the power could be coming from the solar panel and might be a connection point for a ground-based panel.
 

BigHorns

Active Member
Use a volt meter to see if there's 12V DC on those wires. If so, turn the battery disconnect OFF. If you still have 12V there, the power could be coming from the solar panel and might be a connection point for a ground-based panel.

Thanks, Dan. Yes, that's exactly what I'm counting on to be the case. In which case I could easily put the connector back on the side- or somewhere.
 

BigHorns

Active Member
Use a volt meter to see if there's 12V DC on those wires. If so, turn the battery disconnect OFF. If you still have 12V there, the power could be coming from the solar panel and might be a connection point for a ground-based panel.

No such luck. With all power on, the pigtail reads 13.2 converter voltage. With shore power off, it reads 12.5 battery voltage. With disconnect off, no voltage on it. So, it's basically just 12v battery power hanging there. Could be handy though.
 

Dmetcalf

Well-known member
D5F7A0A5-246B-47A4-854C-DB7A9EF9283B.jpeg

mine has this covered plug directly under the Solar on the Side decal. Not sure what it is for ..? Looks like a coax inlet but all of my tv coax connections are on the opposite side of the trailer.
 

Matt750

Well-known member
That is the port you would plug a portable Solar Panel into. From there...it should be wire to the battery bank.

Make sure it is hooked up to the battery bank. On our CY 4007 the wires are just laying next to the batteries. The connection point on the side is the same as my Deltran battery tenders (and I’m sure other tenders). I typically plug in the main 50amp wire when in storage, but I could just plug in a battery tender to the “solar port on the side” to maintain batteries. Nothing in between the port on the side and batteries.


Sent from my iPhone using Tapatalk
 
Top