porch light

[Bobby A]

I noticed my yellow porch light over the door must of burnt out, how do you remove it to get a new bulb?? or is it a sealed unit and you have to get the hole light ??

Thanks,
Bobby

 

[Chainsaw]

You pop the lense and replace the bulb.

 

[Bobby A]

You pop the lense and replace the bulb.

Cool !! thanks a lot.

 

[Ray LeTourneau]

Bobby, Quite a few owners have replaced the existing porch light with ONE OF THESE. Since I installed mine, I leave it on 24/7. In addition to a motion activated light, it also acts as a visual battery system monitor.

 

[JohnDar]

Bobby, Quite a few owners have replaced the existing porch light with ONE OF THESE. Since I installed mine, I leave it on 24/7. In addition to a motion activated light, it also acts as a visual battery system monitor.

Same here.

 

[Bobby A]

Thanks Ray & John, was this one of the vendors at the rally ?? Is it as easy as remove and replace ?? useing the same wireing as original light ??

 

[Ray LeTourneau]

Thanks Ray & John, was this one of the vendors at the rally ?? Is it as easy as remove and replace ?? useing the same wireing as original light ??

Bobby, HERE is the link to the vendor at the rally. Yes, easy install using the existing wiring for the old light. You will have to drill at least one new hole for mounting. It's been a couple years but I think I drilled all new mounting holes. It seemed to be a good idea at the time but I don't remember why. Coil n Wrap has a better price too.
On edit, the supplied LED bulb lasts a very very very long time.

 

[Bobby A]

Bobby, HERE is the link to the vendor at the rally. Yes, easy install using the existing wiring for the old light. You will have to drill at least one new hole for mounting. It's been a couple years but I think I drilled all new mounting holes. It seemed to be a good idea at the time but I don't remember why. Coil n Wrap has a better price too.
On edit, the supplied LED bulb lasts a very very very long time.

Thanks Ray, I'll look into it.

 

[JohnDar]

For some reason I remember the new light having four screws and the old one only two. Probably wrong, but it's not the first time. At any rate, the same wires are used and there is a little test to make sure you've got them connected right. Don't skip the part about applying caulk around the perimeter of the housing before attaching to the wall. You can also adjust the sensitivity, if you like.

 

[TXBobcat]

Here is the new URL at Coil N Wrap for the security light. It's also $14.40 less than the Star Lights Inc website.

BC

 

[Chainsaw]

I also bought the led light at the rally and proptly wired it wrong< I found this out when I could not put it on stand b and the blue led light did not light up. The new porch light has 2 cables marked + you have to get the correct one attached to your + line.