We set up in Casa Grande, Az and the next day I lost power to the fireplace,microwave, all outlets on curb side (2013 Bighorn 3260). Well I'm not too smart but not a fool either so I gets my tester out and start following the incoming power. I started with the GFCI and found a wire just about to fall out. Fixed that but not my problem. Rechecked all breakers then pulled cover off of breakers. Set up like a 240V residential box, two bars with 120V and breakers feeding off each one. All the breakers that controlled the items in question and one of the bars were dead. Now out to the power pedestal (notice how I do everything backwards). However there was power to both sides of the 50A plug. Starting to look like a trip to the dealer! Neighbor comes over and lays hands on and like magic it works now. Later found out that pedestal had been causing problems before I arrived. Went on through 3 states and many setups without problems, then in Port Aransas, Texas it happens again. This was a tough setup and hard to back in etc. so I didn't want to do it again. I used my 50A to 30A adapter, and of course plugged into a different outlet (same pedestal) and all is well. Many setups later we are home and never had any problems after that. This is my first 50A camper and I wonder if anyone else has ever encountered this situation. Going to be hard to convince any dealer there is a problem when everything works. I guess I'll just muddle along as usual hoping all is well.