Recliner Sofa removal cyclone 4200

[Jerapais]

Anyone know how to do this? I broke my release cables and need to replace. But not sure how to remove the seats to get behind couch to access cables. Thanks

 

[FL-JOE]

I would make a call to the factory to see if they could either verbally give you a couple tips or maybe even send you a sheet on the removal.

 

[Sowie]

Start on the left side and remove the screws in the front track through to the floor. There should be two screws per section.

As a side question back to you how is your couch holding up? Ours just started peeling. It’s a 2016 4200. We will be looking for a replacement couch soon.


Sent from my iPad using Tapatalk

 

[Jerapais]

Start on the left side and remove the screws in the front track through to the floor. There should be two screws per section.

As a side question back to you how is your couch holding up? Ours just started peeling. It’s a 2016 4200. We will be looking for a replacement couch soon.


Sent from my iPad using Tapatalk

I did that, and the seats are still attached to each other........
As for my couch, it's been perfectly fine as far as wear and tear and we used it alot. I have heard of this happening with older models though......may want to call factory......

 

[Sowie]

The sections are interlocked at the bottom of the frame. Once the front screws are removed start on the left side and lift up and they should unclip from each other.


Sent from my iPhone using Tapatalk

 

[Jerapais]

The sections are interlocked at the bottom of the frame. Once the front screws are removed start on the left side and lift up and they should unclip from each other.


Sent from my iPhone using Tapatalk

ok I’ll try that. THANK YOU!

 

[Jerapais]

ok I’ll try that. THANK YOU!

Hi Sowie,
Do you have a 4200 and have you actually removed the seats yourself? THANKS!!