I hope I'm not the only one that has done this but while unhitching my Big Country, the breakaway cable got hung up and pulled out. Can someone instruct me how to reattach and if needed how to reset? Thanks.
Tom, there is more than one style, but they all function the same. The thing on the end of the cable came out from somewhere. Find the hole or slot and push it back in.
There should be a small box on the side of your tow pin box. On mine it is near the middle of the pin box on the off-door side of the pin box. Don't try putting it back in at night without a good light (don't ask how I know).
BTW if you cannot get it in in a timely manner disconnect the battery so it won't damage the brakes as when it is out the brakes have a constant voltage going to them which will run down the battery and possibly damage the magnets.
BTW if you cannot get it in in a timely manner disconnect the battery so it won't damage the brakes as when it is out the brakes have a constant voltage going to them which will run down the battery and possibly damage the magnets.
There should be a small box on the side of your tow pin box. On mine it is near the middle of the pin box on the off-door side of the pin box. Don't try putting it back in at night without a good light (don't ask how I know).
(Don't ask how I know)) been there done that, ours hooked on something and pulled out going into a RV park, thought I had hit something when the brakes applied, got out looked around didn't see anything got back in tried to move to our spot,,,man this trailer is pulling hard, got out looked again saw that the pin was out,,ok now try and figure out where to plug it back in with the trailer hooked up to the TV.. finally found it and had to lay in the bed on my back to get the thing back in.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.