Have wired my dishnetwork dual tv receiver as told by back feeding thru the cable terminal to get signal in bedroom tv. Need to know why my signal in basement outlet is snowy and sporadic. Is there a diagram so I can see how things are wired/connected? Thanks in advance. Steve A. Dagro
Satellite /Cable Wiring diagram/schematic
- Thread starter sdagro
- Start date
wdk450
Well-known member
Steve:
The diagram is here: http://www.heartlandrvs.com/product...n&type=Luxury+Fifth+Wheels§ion=downloads#
I also have a BH3670RL (2008 build), and use the storage compartment coax outlet to take my bedroom TV out to the dish for aiming/acquisition. You may have a faulty cable. The cable ends/terminations are the usual suspects.
Recovered from 25-May-2010
Recovered
Sorry. Its a 2011 3670RL, and yes I realize now that none are wired the same. Probably not the same models are wired the same either. Thanks. Steve
circusbear
Active Member
You will need to turn your splitter in the basement around to allow the satellite signal through. It shoulld be behind the basement wall behind the cable wall plate. I had to do this because of the same problem. Sounds like we wired our trailers up the samme. Good luck to yah.
I did it. I removed the plate in the basement. Then the receptacle so I could see behind the wall. Found a splitter there with the 3 wires. Found which wires going to the bedroom tv, ran it to another splitter, out the splitter to the bedroom and the other out terminal I put the basement. Not sure if I added to many splitters but both jacks work now. Thanks everybody for your input. Steve A. Dagro
