What do you call the hole cover you stick the manual crank through on a 5th wheel

[JEMSGEO]

Hello, I am setting my Cyclone up for a double drive for the landing gear and can not find the hole cover for the new hole I drilled in the exterior of the trailer for the manual crank to pass through, anybody have any ideas? Thanks Jim

 

[Jesstruckn/Jesstalkn]

What size hole Jim ?


Sent from my XT1585 using Tapatalk

 

[porthole]

Mcmaster-Carr

 

[Jesstruckn/Jesstalkn]

I like using these gladhand seals as isolator to run wires and brake lines through. They work really well.
I use a large step drill to make the hole.

Sent from my XT1585 using Tapatalk

 

[JEMSGEO]

Thanks this the part I need 1 1/4" dia

 

[porthole]

Call Heartland

 

[JEMSGEO]

Call Heartland

Ok Thanks!!

 

[pegmikef]

Ok Thanks!!

I have better luck using email with Heartland than I have had calling them. Just send them the pictures you attached above and explain what you want. They will look up the part and send you the part number and ask you if you want to order it or give you the number of the parts department. They usually respond to your email the next day..

Include all the info about your rig, especially the VIN#

 

[JEMSGEO]

I have better luck using email with Heartland than I have had calling them. Just send them the pictures you attached above and explain what you want. They will look up the part and send you the part number and ask you if you want to order it or give you the number of the parts department. They usually respond to your email the next day..

Include all the info about your rig, especially the VIN#

Thank you for the advice!!