u243412
Active Member
Some things I did to our 3010...
- changed that table top to a swivel.
- add a wire mesh piece under the 2 propane bottles - that's where my wheel chocks now rest. (2 chocks per side)
- solar panel hooked up to the 2 - 6V's
- added bottom trim in garage above the checker plate so quads don't tear up the wall paper.
- made some skylight and bedroom window covers (velcro on/off) - I like to sleep in once and a while.
- added shelves to a couple spots in the bedroom closet. (we don't have a washer/dryer installed.
- added a cover for my gas dispenser nozzle - it gets really dirty back there.
- use my rear grey tank to store my sewer hose and elbow.
- Broom and mop holders in garage
- labeled all the stupid buttons that Heartland failed to label. Cable locations (3), Black flush connection, light switch, etc
Some things I'd like to do (or are thinking of how to do)...
- remove the hydraulic arms on the front left slam door and have it lock upright like the opposite side slam door.
- install "drag bars" around my rear electric stabilizers. I've bottomed out and dragged my spare tire a few times now.
- add those Walmart carpet pieces to the steps. But I think there's not enuff clearance when you flip up the bottom step.
Anyone care to comment if the carpet pieces from WallyMart will fit without binding on the upper step?
- changed that table top to a swivel.
- add a wire mesh piece under the 2 propane bottles - that's where my wheel chocks now rest. (2 chocks per side)
- solar panel hooked up to the 2 - 6V's
- added bottom trim in garage above the checker plate so quads don't tear up the wall paper.
- made some skylight and bedroom window covers (velcro on/off) - I like to sleep in once and a while.
- added shelves to a couple spots in the bedroom closet. (we don't have a washer/dryer installed.
- added a cover for my gas dispenser nozzle - it gets really dirty back there.
- use my rear grey tank to store my sewer hose and elbow.
- Broom and mop holders in garage
- labeled all the stupid buttons that Heartland failed to label. Cable locations (3), Black flush connection, light switch, etc
Some things I'd like to do (or are thinking of how to do)...
- remove the hydraulic arms on the front left slam door and have it lock upright like the opposite side slam door.
- install "drag bars" around my rear electric stabilizers. I've bottomed out and dragged my spare tire a few times now.
- add those Walmart carpet pieces to the steps. But I think there's not enuff clearance when you flip up the bottom step.
Anyone care to comment if the carpet pieces from WallyMart will fit without binding on the upper step?