If you install a washer and dryer, it might be best if you lift up the bed, remove the left panel and check the flexible drain hose. Ours became completely disconnected on one end and was wedged under the bed and was also
loose on the other. Needless to say we had quite a flood. The drain pipe is actually too long and causes a lot torque on the flexible drain hose fittings when the slide goes in and out. See the attached pics. BTW, the hot and cold lines were reversed and all the plumbing next to a 120V junction box.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk