Recent content by BlackT

Correction to my previous reply - We have a Curt A16, not E16 as previously stated. Same rating, different design. I guess my memory is starting to go.

We have a Curt E16 and pull a trailer with a weight rating of 15,500 lbs and actual loaded weight of about 13,000 lbs. We haven't had any problems with it, but in retrospect I probably should have gone with a hitch rated at 18k just for the peace of mind.

I have a 2015 Torque 321 and the water pump is behind the pass through storage aft wall. Access is gained by removing the wall by removing several screws. The water pump is on the floor near the furnace. Hope this helps.

Re: Cheater Cord - 30 & 15 amp combiner GFCI works by comparing the current passing through the line (feed) conductor to the current passing through the neutral (return) conductor and opening the circuit if they do not match exactly. When the cheater adapter is plugged in, it connects the...

Re: Cheater Cord - 30 & 15 amp combiner I tried one of those things. It will not work if the electrical supply is protected by GFCI receptacles. As soon as you plug it in, it trips the GFCI. I haven't been to a park yet that at least the 110v receptacle wasn't GFCI. I think they probably have...

We bought our unit from them in 2014 and did not have any problems with them. We picked up our unit at their place. They also offer delivery. The pre-delivery inspection was a bit brief, but the overall experience with them was good. You need to really research your unit beforehand to be sure...

Re: EVENT: Heartland Chapter Rally: TX, Port Aransas - 10/6/2017 to 10/8/2017 Please mark us down for two large tee shirts.

Re: Welcome New West Texas Chapter Members! Thanks for the warm welcome all. Our first rally will probably be the Port Aransas Rally in October. Can't wait!

We have a 2015 Torque 321 which may or may not be the same as your 2017, but we had the same problem and this is what worked for us. First we did the Tim K tent mod described on a sticky somewhere in the forum on the back ac and that made a tremendous increase in airflow out of the vents. We...

About a year ago a similar situation occurred on my trailer slide out. One of the slide pull cables had come loose allowing a bottom roller to overload the waterproofing material. I sanded the spot down to good wood and used 'Splash Zone A-788, Half Gallon Kit - Pettit Paint' (google it) to...

Hobie Pro Angler 12 fishing kayak and more fishing equipment than anyone should be allowed to have.

PDay1213 - The first failed regulator leaked from the weep hole. The second failed regulator worked for a while and then restricted flow so much that I could not keep a stove burner lit.

Tim, If you need a switch, I have one I can give you. I sent you a PM regarding.

Redharleymn - Is your trailer a 5th wheel with a factory installed generator? If so, there should be another LP regulator near the LP tank on the opposite side of the trailer from the auto switch over valve. This regulator is set at 30 psi and feeds the low pressure regulator at the auto switch...

I installed a set of JT Strongarm stabilizers on my Torque 321 and they made a tremendous improvement. The didn't eliminate 100 percent of the shaking, maybe about 80 percent, but they are well worth the investment.