Recent content by cj11302000

I just took a trip from Western Washington over to Eastern Washington for a camping trip with my 2009 Sundance 2997BHS fifth wheel. When I got to the campground, I did notice that the trailer appeared to be sitting lower on the passengers side...but me and a friend thought it was because I was...

I've seen a lot of talk about landing gear problems and I've posted about them before. Before I buy a new motor or convert to two motors...I'd like to properly lube and inspect the insides of the landing gear. Does anyone have detailed directions or photos on how to do this? I'm not nuts...

Thanks for all the information guys!! Love this forum. I am able to move the jacks manually with the crank without breaking my arms off, so I'm not sure it's a lubrication issue. It's just so bizarre. The motor runs really slow and just sounds like it's working really hard...then just stops...

I have a 2009 Sundance 2997BHS fifth wheel and for the most part have been very happy with the unit. When I first bought the unit, the front landing gear jacks failed on me. A pin inside one of the jacks broke and wouldn't work. The landing gear and motor were covered under warranty...but...

I talked to Lippert and they want me to check voltage under a load. They said that even if you're hooked up to shore power or a tow vehicle...the motor runs off the coach battery...so, he said that a bad battery can cause all kinds of problems. I'm going to check voltage tomorrow and replace...

I have a 2009 Sundance 2997BHS. I had an issue early on with the landing gear. A part broke in the gear portion of the landing gear. The problem was fixed under warranty and the motor was replaced. I remember Lippert telling me that the motor put on by Sundance was not powerful enough...

Attached is the picture of the landing gear rocker switch on my 2009 Sundance 2997BHS. Anyone know who makes this or where I can get one? Thanks.

I'm trying to find out who makes the landing gear rocker switch on my 2009 Sundance 2997 BHS. Anyone know who makes this and where I can get one? Pic of switch attached. Thanks!!

Thanks Dave...still waiting for a reply though...nothing yet?

Waiting for reply... Dave, still waiting for a reply on this from a plant manager...Chris

We have a 2009 Sundance 2997 BHS and we just love it. We recently went "winter camping" at the ocean here in Washington State and it was pretty cold. We ran the furnace a lot to keep the trailer warm. We noticed our friends dog kept laying on a spot on the floor in front of the fridge. We...

I read too about how the ducting gets all pinched under the stairs and the space cut by the factory was too small. I took off the stairs and sure enough, the space cut for the two ducts was too small and they were being pinched. I cut the space bigger and laid them side by side with no...

Shanise, I'll try to remember to take some photos and post them to show what I did...so far it has worked.

I'll try to take a couple of pictures in the next few days...

Just FYI for those of you who may be wanting to tackle this job. I recently purchased a Shurflo Platinum remote variable speed vent fan with rain sensor to put in the vent in the bedroom of our 2009 Sundance 2997BHS. It really wasn't that bad a job. I used a plastic putty knife to take off the...