Dahillbilly's latest activity
-
This site has an excellent repository of manuals you can find under Tools above (https://manuals.heartlandowners.org/) You'll find... -
Dahillbilly replied to the thread Wheel upgrade.better upgrade the spring hanger bolts with a wet bolt kit, add new heaver equalizers also. then go with disc brakes. I did all these on...
-
Dahillbilly replied to the thread Does Heartland hate us?.same result when I ask for a wiring diagram for our 2017 Torque 327, they just run the wires.
-
Figures 7 & 8 on this page explain the correct wiring for both 30 and 50 amp shore power receptacles. Have your electrician get it...
-
Dahillbilly replied to the thread inwall slide controller location.haven't heard of a cable system with two motors, but I will suggest looking in the tool tab above for user guides/ slides & see what you...
-
Dahillbilly reacted to cookie's post in the thread Broken Leaf Spring - Looking to Upgrade Suspension with
Like.
I've upgraded the springs on my rig from 7k to 8k. But, the axles are still 7k. So in don't that i raised the rig about an inch and I... -
Dahillbilly replied to the thread 12v Rear Slide out LED's in bunk/overhead not working..glad u were able to find the problem & thanks for sharing the results
-
Dahillbilly reacted to jwb2's post in the thread 12v Rear Slide out LED's in bunk/overhead not working. with Like.
Found a resolution. It was not the junction box. The underside by the slides, closest to the rear tank on each side. I removed the...
-
Dahillbilly replied to the thread Slide won’t work.from the tools tab above should have the info needed, https://manuals.heartlandowners.org/?man=Slide_Outs/Rooms
-
Dahillbilly reacted to travelin2's post in the thread 2 way refrigerator on its last leg, Recommendations? with Like.
I’ve read some posts they fail to keep cold. and a friend had a 12v in their grand design replaced twice under warranty. Once on a trip...
-
Dahillbilly reacted to rhodies1's post in the thread Please help I cannot figure what color wire goes to what color wire in fifth wheel pin box with Like.
Take your time and unhook the wires. Start by reconnecting one at a time time to see what lights come on. Mark that and move on to the...
-
Dahillbilly reacted to rhodies1's post in the thread 2 way refrigerator on its last leg, Recommendations? with Like.
the new 12 volts are supposed to be the cats meow. Most RV manufacturers are installing these versus the old propane/120 volts...
-
I got it in, I cut two lead angles on back of the 'D' and that gave it a lead going down the track. I see the top rail is plastic and...
-
I just received new seals for my slides, the retracted seals. I ordered them from Steele Rubber. I guess I will be working on that this...
-
Dahillbilly replied to the thread Big Country.my inner slide out seals failed first & then the outer ones on the bedroom slide, yet the main slide seals are still good
-
Dahillbilly replied to the thread Milestone Plumbing Question.I've seen others post the same question on different models, seems as if the factory had mis-plumbed their the rig. Contact Heartland...
-
Dahillbilly replied to the thread Exhaust fan in roof.Torque has rocker switch for vent cover & fan near doorway into garage
-
Dahillbilly replied to the thread Gen Y gooseneck.the Crosswing is light weight for sure, that's why I purchased it. The problem I encounter was it's not designed to be used in...
-
Dahillbilly replied to the thread Dometic 9100 motor “clicking”…not just the motor.bad connection or low voltage would cause the clicking
-
Dahillbilly replied to the thread Fuse location.our alarm has it's own in-line fuse, found it when I did some repair work to the kitchen cabinet
-
Gang: I was doing some research on Fantastic Fan motors this evening, and I wanted to remind you all that Lippert, Heartland, Dometic...
-
Thanks for the input everyone. I removed the whole furnace which was waaayyy easier than I thought. I wnsed up unplugging the circuit...
-
Dahillbilly replied to the thread Mallard M185 Furnace.sail switch may not be working; it has to close for the spark ignitor to work.
-
Dahillbilly replied to the thread Trim on slide out.mine always has one cable loose; as long as it opens & closes tight, I leave them alone. Like Cookie stated above read the guide for the...
-
Before you decide to tighten that cable be sure to read the proper guide on how to do it. Check it out in the Tools tab above. On some...