Since I plan to varathane everything I think I am just going to touch up the damaged areas (I still have some leftover paint) and then start my three coats of varathane. The only thing that worries me a bit is getting a little varathane on the walls since I don't want to spend the time masking...
It's been a while but here is the latest update. First of all, we decided to put carpet back but just in the slide. We had it installed but the edging was coming off. They took it back and looked for someone who could make a better edge. Took them a long time but it is coming today. My...
An update to our restoration. We finished everything finally but we aren't sure about the vinyl plank in the DR/LR slide. It leaves a channel at the edge that we just can't fix. Tried various things but it looks like we will go back to a carpet just in the slide.
We replaced the broken...
I did remove the switch. Turns out it is a small control board part #3851144018. It's $60 plus shipping from a few places. Not sure if I should get one. I can't tell if it is broken or if the issue is somewhere else.
I may try cleaning the switch on the board by putting some alcohol on it...
This morning we were woken by the sound of running water and found our fridge water dispenser spilling water all over the floor. pressing the switch stopped it but while cleaning up it started running again. I assume that the switch in front is the problem but I can't find anything on line...
It stayed up all night. This morning I switched on the breakers for GFCI (I need my coffee) and hot water heater. Within minutes the power went out again. I turned off the hot water heater and now it seems OK but it hasn't been that long.
This time the EMS showed a P03 error so I guess that...
Yes. Unless it is somehow reporting incorrectly then everything at the pedestal seems to be fine. I was surprised that the voltage was 128-129 though. That seems higher than I am used to seeing.
Suddenly today I started losing all my AC power. It would go down for about four minutes and then come back on its own. After a while it stays up longer. It has been up for 1½ hours this time, the longest since the problem started. However, I have turned off the breakers for most of the...
Really? I tested it and it works. In any case, here is the sequence to find them from the top level:
RVing
Restoring our Heartland Landmark
Replacing the Floor
The Final Result
So our table is now unattached to the floor and I can't find the original screws to hold it down. We had removed them a few years ago so that we could re-orient the table. With the carpet we never found a need to screw it down. With the vinyl (we went with glued down plank vinyl) I worry that...
Well, we are mostly finished the restoration. A few bumps in the road but it is looking good. We have a few more things to do in the US when we head south in November.
One problem, somehow the glass in the door over the desk came loose and fell out. Broken. Need to figure out how to replace...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.