We do not install wiring for these lights. You would have to switch the fan off of the light. The power vent and the lights both have their own on/off switches.
As with all Heartland products there are continual changes and updates to the décor's and options as each model year arrives. The length of time that items will be available for the Edge product, like all our products, will depend on current stocking levels within our warehouse, vendor...
The brochure states that the interior of the unit is rated for 0 degrees and when the furnace is running the unit will maintain the heat. If you are to utilize your water system you will need to take other steps that dealers will offer. Skirting is an option customers take as well as heat tape...
You could install them, however, the roofs that are installed on our products are different than that found on a different product. We install a solid laminated roof on the NT Travel Trailer. If you were to install vents there is no room to air to flow between them.
I would not cut the hole any bigger, I would remove the screws from the outside edge and drop the underbelly and view across at it. the fresh tank is located directly over the axles. your grey and black tanks are positioned towards the front of the unit. I think you may have gotten lucky on...
the linoleum we use in our products have a foam backer unlike many other linoleums in the market that have a paper backer. The indentation should come back a little over time but after awhile of sitting may not. You can ease this by installing a piece of thin plastic or even a section of luan in...
I would discuss the installation of a new underbelly by a dealership or service center. once it gets to the point you are describing it should just be replaced, does not take long, a lot of screws and they have to cut around the components. I recommend walking around it with a spray foam over...
Re: Help - Underbelly leak - need schematic
All of our tanks are made to be removed. the sides of the tanks are held up by cross members (angle iron) one is welded in place and the other is lag screwed into place. the one that is screwed is the one that can be removed so the tank can be removed.
Indentations in the linoleum under the refridgerator or any heavy slide out is a common occurance. When the slide out is in the weight of the slide out will sit on the lino and cause this. Heartland has made this issue better by going to a 12" rubber roller rather than a hard plastic roller...
We install backers behind the awning rail that extend past the rail to attach the top of the awning arms to. the backers consist of aluminum tubing and galvanized sheet metal, if you are looking for a wood backer or something bigger you will not find it. you should take the unit to your dealer...
We get them from
Kemberly
1120 N. Main St
ELKHART, IN 46514
Ph-574-264-3131
Part# 12562
You can contact Heartland parts for pricing and shipping if you wish to purchase it straight from us. 877-262-8032
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.