Recent content by Flanman5

Correct so I will chip out what above the drain line and clean up the inlet line and heat tape it and re spray foam... Thanks again. Edwin

Thanks for the response. I have dropped and discarded the coroplast and had the whole bottom from front to back spray foamed. I also heat padded all the tanks before spray foaming. Now with this info about the drain and tee I will be build a heated something for the drain... Thanks again, I...

No one has an idea of where the inlet from the anderson valve does in to the water tank? Is it Teed in off the drain valve? Is it a hole on the side and if so what side? Thanks a bunch.

I have a 2012 Torque 291, was wondering where the outlet to the pump from the water tank is? Is it at the top or Bottom of the tank. I dropped the coroplast last year and spray foams it, installed tank heaters but still it froze. Any info and pictures would be great thanks, Edwin

Don, Do you have any pictures of how you did this? Thanks, Edwin

Same thing happened to my Torque 291... Self Tapping screws in the center below the door took care of that.

We stayed at Rush No More campground this summer days before the rally. Awesome place, awesome people and awesome owners. Would highly recommend this campground.

Not sure why they changed from the older systems that worked great in years past. I buy a new holiday trailer every 4 years and this is the first suburban furnace. Not liking it at all. The Trailer itself is great. Other then a few minor issues that were dealt with but none the less great...

I had an Atwood in my last trailer and for 5 years never had a problem. So I would say it's a "good one"...

Wow this seems to be a big problem. Let me guess the blower doesn't bow either? Suburban furnaces, I must say, are absolute garbage... Heartland we have a problem....

Mine would do this same very thing. I would turn it on and off and nothing. I would go out and take the cover off the furnace then unhook the wire to the blower motor then plug it back in and boom it would work for a week or so. I am going to get it in to a dealer and get it fixed as I will need...

Dane, You don't have this schematic for the 291 Torque do you?

Last time I had that problem it was the regulator was not putting enough gas to the burner. It was explained to me that propane has a wax in it and my tank was excessive on the wax side of things and buggered the regulator. Changed the regulator and cleaned the rubber line and never had a...

Normal is for the pump to draw water out of the tank, At least thats how that valve is set up on my Torque...

Well I replaced the thermostat and starts at 73 once then no more restart no nothing. I shut it off till it clicks up top, then set it to 79 and it works. Any Ideas?