Recent content by Hotrodbud

Thanks for the input! Never considered the wireless option, much easier than running wires! I wonder if I could just use one receiver, then into a splitter, for the basement and bedroom TVs. I could put the receiver and splitter in the cabinet at the top of the stairs, and easily route cables...

Hi all, I want to run 2 HDMI cables from the satellite receiver in the rear entertainment slide out, up to the bedroom and basement of our Bighorn 3670RL. Looking for any advice on getting it thru the back half under the floor. Do I need to drop the coroplast? I would rather not do that, but...

The electrical pedestal at our seasonal camp site is 15 ft forward of our BH 3670RL. I have to have a 20ft extension cord plus the 35 ft off the reel to reach the pedestal. We do not have a generator, but the BH is wired for one. I'm thinking of wiring plug into the generator box in the front...

I just had that stuff apart on my Bighorn. What you really need is a screw gun and some #6, 3 inch screws. You can probably take the trim off, remove some of the screws, straighten them, and reinstall them. If you are lucky you wont have to mess with the rubber seal. Its a 1 inch thick plywood...

I just got one from Amazon two days ago for my Bighorn, found one broken while replacing the brakes. The shock had p/n 122108 stamped on it. A little searching around and I found the complete P/N is 14122108. Amazon has it for $21.

Yes, codycarver, Top of the World and the whole Cooke City area is pure snowmobile heaven! You probably live close enough to get there often, you lucky dog!!

We have been looking at mattresses too. The one in our Big Horn says 70" x 80" on the tag, and it fits tight into the slide out. The slide out "headboard" actually measures 71" wide. So will a 72" RV king mattress wedge into a 71" space? Anyone else ran into this issue? Thanks for any advice.

My 99 F250 7.3 crew cab 4x4 has 82,000. Always garage kept, lots of engine mods, looks like new. I'd like to have a new 6.7, but just can't get over the new price tags! Has a lot of engine mods, looks like new.

So I got a cut on the side wall of a Sailun S637, now need a replacement. Where is the best place to buy a Sailun tire? Anyone know of any dealers in northern CA ? Thanks for any advice.