We have the 2812, I am not sure what you are going to put in the garage, but, we have put 2 large utility atv's, a portable generator, and a 50 dirt bike and have had no problems.
We had the same problem, when running off tank water the pump would run about every 10 minutes. We took it back to the dealer and they said it was bad and replaced it. I would have it checked.
We just got back from camping and while out water from the pump filled the basement storage, along with everything in it. This will be our 3rd pump. Glad to hear were not the only ones but seriously doubting the quality in heartland.
We are able to run 1 ac unit with the honda 3000 generator. We don't put it in the compartment but, I think there is a different door with venting for the gen compartment.
We pull our 2812 with a 2500 GMC short box and opted to get a slider when we first had it installed, my husband backed it in the driveway several times without moving the slider, very doable. One day he thought lets move it and see if it's easier and it was, so much easier to get backed in. So...
We have a 2011 Cyclone 2812, we had several small problems when we first got it but after several trips back to the dealership everything is starting to look up. We still have a graphic that is pealing and awning that is falling off, but the minor things like the water pump running, closet door...
We haul ATV's and the tie downs were not in the right spots. We got more at Northern Tool. They come in a pack of 4 or 6 for low cost. My husband used a round drill bit and chisseled out the center to countersink them. Worked great and looks good too.
We ended up getting on that the roll slides on so you only have one set of holes in the wall and found a stud in the center of the wall. Worked out really nice.
On that same note does anyone have a great way to locate where to put the toilet paper holder in the bathroom of the 2812?? We have yet to mount it and the dealer said they don't do that. Heartland said use a stud finder, they don't have a blue print. Thanks
We have the 2812 and mounted it almost directly under the hook up. If you call the factory they will email you the blueprint of the wall so you know where the header is. That worked for us. Good Luck !!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.