Recent content by MichaelV

UPDATE: There is a brace that runs from one side of the frame to the other. The crack is where the brace is welded to the frame so it is racking. I have a tight turn where I back the trailer into the spot next to the garage. I bet that is when it is moving. I have to remove the coroplast sheet...

I have a 2" long crack on both sides of the frame on my '17 23RBS. They are located about 2" in front of the very front spring hanger about 2" from the bottom of the frame rail, running horizontally. I don't know as of yet what is causing it. To stop the crack I took a 1/8" drill bit and drilled...

The water pump is located behind the left panel with four screws if you are standing in at the sink. A lot of the time the noise is coming from the lines. If you remove the front panel to access the pump, remove the mounting screws the hold the pump down and install a piece of rubber between the...

Hi Don, call here https://colawrvparts.com. 18775482125.The part number for my NT 23RBS is R854056. I bought a 150' roll for $1.50 a foot + shipping. Mike

If anyone is interested, this is how change out the side wiper seals on your slide outs. First: Each rail/tract that holds the seal has a crimp at the bottom so the seal does not slide out. This can be opened back up using a flat tip screwdriver. Now slide out the seal, measure, cut to size. You...

Thanks for the reply. They are the 1.5 inch strips. I removed some foam insulation at the bottom and noticed the channel they slide in was crimped a little so they could not slide out. I opened it up and slide out the old one. Heres a caution. I live in AZ where the temps lately have been about...

I have a '17, 23RBS and the side slide seals are tearing and coming out of the slot. I don't see a provision to remove the seals. I don't see any fasteners or means to open the channel that holds the seal in place. Do they just slide in from the bottom?

It may be but that's the long way around being the breaker panel is in the island, so they would have to go up to the front under the cabinets where the outlets are, then up the front wall and back under the cabinets. I will figure this out this week as I am going to install an inverter in the...

Time to pull all the "Warning" stickers off! They put them on everything except the toilet Mike

Ok. I removed the front stabilizer jack controls and its not the same wires. What ever it is has to be 110v. There is 1 romex running thru the front frame already so I don't know why this would come out of the front wall and down into the floor? Still thinkin.... Mike

I don't think so as the controls are a foot away and front/rear have separate controls. It looks like it runs up the front fiberglass nose piece but the a/c is in the rear. I will take the cover off the front jack controls and see if the wires are in romex. Mike

I can't post pictures, but anyone that has a "15-"17 23RBS can't miss the 3"x7" black box on the floor inside the front storage compartment. Mike

No. I am talking about IN the front storage compartment on the floor against the front wall, to the right, is a black cover with two screws. Inside is what looks like a 110V romex wire. What your talking about is outside on the left front.

I have a North Trail 23RBS. What is the wire for that is that is located under a black plastic cover in the right front storage compartment?

Maybe a demo of the currently used RV urethane foam sealant burning would be an effective educational tool for Mac The Fire Guy. That's exactly what is needed. We aren't going to change the industry unless more people are aware and raise their concern. That's the whole reason I began this...