Recent content by Relayman

One of the left brake lights us not working on my 2017 Bighirn fifthwheel. Has anyone ever replaced one ?

One of the ivak taik lights on my 2017 3270rs is not working. Anyine have experience in replacing one ? Thank you in advance !!😊

Has anyine experienced fram cracks that allow excessive pin bix movement ? How do you tell if you have a cracked frame issue ?

Has anyone ever modified and raised The sewer drain outlet/ plumbing on tjeir 3270rs camper ? Mine is under tje fram, and is so low , the campground sewer inlet is often higer than my campers outlet !!! I hate " walking down" the slinky !!!!

Anyone ever pulled a 5er fron Dayton to Cody Wyoming over highway 14 ?

Anyine ever travel from Texas to Montana ? Whats the best rv friendly route ? What to watch out for ? Thankyou in advance.

We have a 2017 Bighorn 3270RS with a residential Fridgedaire refridgerator and its throwing. SY CE code on the display. Anyone seen this ?

We are experiencing a foul order in our camper when my wife runs water in th island kitchen sink. I have replaced the air admittance valve from one that came from Lowes. It was $25 so I presume its a good one. Hasn't helped. I bought an endoscope that connects to my cell phone and ran it down...

jason moses Sent from my SM-G930V using Tapatalk

I used my brad nailer to re attach mine. Sent from my SM-G930V using Tapatalk

Took my inlaws ( 81 / 90 ) to Branson for a week so I Installed a Stromburg Carlson handrail on my rig to help them up and down the steps. Worked Great. Sent from my SM-G930V using Tapatalk

Thank you ! we will get.er done with our "appropriate" side dishes !![emoji4] Sent from my SM-G930V using Tapatalk

nander...the pot luck dinner....can yoh tell me what meat is provided so we can prepare appropriate sides ? Sent from my SM-G930V using Tapatalk

shoot....when I was in the Navy, our Chief cook smoked, and the only ash tray he used was the pot he was stirring !![emoji44][emoji44][emoji44][emoji44] LOL. Sent from my SM-G930V using Tapatalk

HA HA HA...I went to Wal-mart, bought a 3/8" teflon cutting board, put a couple strips of 2" masking tape...took the top bracket off, traced four patterns...cut them out ( drilled the holes first )..cut them out. I also took a knife file..and cut a vertical groove on each so they would not hold...