Did you check the breaker (not a fuse) for the washer outlet? Also my fuel station has a timer button in the control cabinet that needs to be pushed before the pump can be activated. There is a lever on the pump to lift after to turn it on.
Sent from my iPad using Tapatalk
Look up Cyclone loading ramp failure started by Porthole. I haven’t figured out how to cut and paste the link on Tapatalk app.
Sent from my iPad using Tapatalk
Yes mine was sagging at the floor. I never checked the roof portion of the slide to see if it was sagging proportionately. Is yours only noticeable along the top?
Sent from my iPad using Tapatalk
Check for bent bracing under the slide. Mine had very thin angle brackets that had bent down. I welded heavier gage steel brackets to the frame and all good now.
Sent from my iPad using Tapatalk
If it’s the winegard connect 2.0 it is a combination WiFi range extender from campground service and also if you pay for a data subscription a cellular data receiver. Everything is built into it and it transmits the signal to your WiFi devices like in your home. You would need to pick either...
if it’s delaminating and spongy I don’t know of any way to fix it. It’s made up of a sandwich of exterior skin, styrofoam and then thin luan wood with a non skid glued to it. You maybe could cut out the bad luan and splice a piece back in. On mine I had to have the Lippert door replaced. Before...
The sections are interlocked at the bottom of the frame. Once the front screws are removed start on the left side and lift up and they should unclip from each other.
Sent from my iPhone using Tapatalk
Start on the left side and remove the screws in the front track through to the floor. There should be two screws per section.
As a side question back to you how is your couch holding up? Ours just started peeling. It’s a 2016 4200. We will be looking for a replacement couch soon.
Sent from my...
I have pictures of my replacement of my side patio on a different thread. Cyclone 4200. Heartland provided new patio and I did all labor. Before I installed it I took rear and side ramp to local Rhinoliner company and had both sprayed a light gray. Then found while re assembling the bolts that...
I also have the Pedal Commander installed that allows you to adjust the sensitivity of the throttle. It works great with no problems. You can adjust it on the fly through BT on your phone. No real power gain but eliminates the throttle lag. It takes about 2 min to install.
Sent from my iPad...
Same exact thing happened on my Chevy. I sent it back and should have a new one in a couple days. Not feeling real confident this was a very good investment. I’ll give it another try and see how it goes.
Sent from my iPad using Tapatalk
Just an FYI for anyone looking to purchase the Dr Performance module. Apparently they are also the same unit marketed as Stealth Performance and also another name that I can’t remember. Shop around as the Stealth was $50 cheaper than the Dr Performance for the L5P Chevy. Also there is a YouTube...
I had mine replaced under warranty and had spray on bedliner applied to new one (side patio) and also did the ramp. I sealed all the bolt holes when putting back together. Did all this in 2017 and still holding up great.
Sent from my iPad using Tapatalk
I am also thinking of removing the sink so I can get my Honda pioneer 1000-5 in. I am thinking though of some kind of brackets to hang the sink on and still be removable when I need to. Anyone have any ideas for a bracket?
Sent from my iPad using Tapatalk
I know this is an older post but I’m about to pull the trigger on a P1000-5 and going to try and squeeze it into my 4200. Does anyone know if theirs fit with the add on roof?
Sent from my iPad using Tapatalk
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.