Recent content by timdebs

Finally got slides and landing gear up manually! John at Lippert told me you should be able to all to work even if motor is messed up. He had me go out to camper and while on phone with me read manual to make sure I was doing everything correctly. That did not work. John then said try turning...

I have not tried the slides since replacing trombetta,I did not even think about that. Tech at Lippert did not mention that either. The slides were working fine before. I will try tomorrow. If worse case the slides no longer work, I assume I will use an allen wrench to turn valves and pull one...

Update on landing gear not going up...been talking and working with Lippert trying to get landing gear up. The tech guys I have been talking with at Lippert have been great! I assume I have been running pump so much trying to get landing gear up the trombetta (solenoid) got really hot and melted...

I have 2 switches, 1 on the front outside of camper and the other inside front compartment by the pump. I will try to operate like the document you sent. Thank you very much! Will let you know.

We do not have level up option. The motor runs and will extend legs. When I try to retract the motor runs but sounds like it is cavitating. I did disconnect the hydraulic hoses on legs and picked legs up.

We have a 2009 Landmark Pinehurst. Our landing gear is extended. I can not get landing gear to retract. Can extend but not retract. I used pump jacks and picked front up in case legs were in a bind. Legs just dropped more. If i toggle the switch up-down fast landing gear moves up just a little...

Re: ATF: Landmark - Slide in/landing gear stalls I talked with David and Art at Heartland, their reply was to replace the relay. I went to Car Quest and bought one for $10.37 including tax and so far both slides and landing gear are working great. I did buy a spare just in case. Hopefully it...

Our door slide, off door slide, and landing gear stalls when pulling in or letting out. I have read forum and owners talk about a breaker. Is this what you recommend? Thanks Tim

That is the first diagram I have seen of how to actually install it. Thank you very much!, Tim

As a Heartland Landmark 2009 owner I would like to thank Heartland Customer Service Department. I called Heartland this morning and Customer Service transferred me to "Art". He answered all my questions and offered suggestions in a way that I could understand. Later, due to my post on "Ask the...

I would like to thank all the Heartland Owners that so kindly responded to the question on my flooring issue. Everyone's input is much appreciated and helpful! I am thankful to have this forum!!! Thanks again Tim and Debbie.

Gary that sounds like the thing to do. Thanks for all your help!

Jim I understand as a manufacturer you have to do it, but as an owner do we need it? Thanks, Tim P.S. the reason it took so long to find the leak is because I assume (and yes I know what that spells, especially in this case) the only time it leaks is when I was washing out my black water tank, I...

I have been trying to remove rotten osb sub floor, trying to be careful not to remove styrofoam that floor is glued to, but impossible to do. I am using my oscillating saw cutting small cuts. Is there any easier way? Some styrofoam did pull up with wood. Planning on calling Heartland tomorrow to...

The leak (I assume) was the black valve behind the shower stall that keeps water from backwashing into your water lines from the tank wash water line. Not really quite sure this is correct but removed part and went to RV parts store, parts guy said it was your leak and to remove it all together...