Recent content by Warnerelli

Dan, thanks for that information. I have it in hand to take to the dealer with me when I return next week. Good information. As I left the dealer today I noticed my 08 sitting on the lot . . . as I passed I whispered "I miss you" :). Jim

Well it happened. Just 19 days after purchase and less than 700 miles on the odometer I got my first DIC message indicating my Diesel Exhaust Fluid (DEF) was limited to 998 miles. We discussed the new emission regulations with the 2011 Diesel’s and the addition of the Urea Tanks in a past...

Dave, thanks for the input. I have traced both of these valves from behind the wall. The one labeled low point drain does in fact go directely to a hose that extends through the belly of the cyclone and is a low point drain, however, it is the only one. The valve I have in question I cannot...

I have one valve in my docking station (2008 Cyclone 3912) that has no label and the manual does not make any referenced to it. I am hoping one of you with a similiar or same docking station can identify the valve for me. The valve in question is in the left hand photo and would be the valve...

Do yourself a favor and before you buy any cover check the Access Roll Up covers out. Here is the site: http://www.agricover.com/index.php/products/category/C9/ I have had three on three seperate trucks and they are low profile, look good, extremely easy to open and close quickly and durable...

As always with this particular question there are many opinions and I am about to add mine. I recently purchased a 2011 GMC 2500HD Duramax/Allison Crew cab 4X4 Sierra. Even though I am fond of the GM product I researched all three makes. 2011 models of the Dodge, Ford and GM are very...

Lots of good advice has been given here . . . experienced advice. Best I saw was alway's have more truck than you need.

Really appreciate everyone's comments on this issue of "bucking" and the remedy's many have tried. I decided to stay with my current hitch and go with the Trail Air Tri Glide Air Ride Pin Box. Purchased it today and scheduled to have it put on in May after I get the snow off the cover. I...

Took possession of my 2011 GMC Sierra 2500HD Duramax/Allison last night. Spent most of the night reading the manuals, etc. I spent today playing with all the bells and whistles and a drive through the Northland. She sure is sweet riding and driving. I know we will have below freezing temps...

DW and Ziggy, again thanks for the information. DW good information on the "time consuming" process of lifing the cyclone to hitch level with electric (which I have) and Ziggy you have me thinking about the center point. Thanks again.

Thanks to all for your comments and information on hitches and pin boxes. Lots of good information provided. Might be the time to upgrade the hitch. Will make my decision after attending a couple of RV shows here in Mn this week and next. Will check back here to see if any further...

I will be taking possession of a new truck (2011 GMC 2500 HD Durmax/Allison) in a few days. While removing my current hitch (Husky Slider 16K) from the old truck I gave some thought to the bucking that occasionally went with towing our cyclone (2008 3912) on rough roads. Looking for advice from...

I am a big time believer in the Access line of covers and have had three installed on different trucks. The last one I installed is the Access Tool Box Edition Truck Cover that butts up to a tool box. The web site is: http://www.agricover.com/index.php/products/category/C31/. I believe this...

Mike, Several variances are involved with max tow capacities, i.e., crew cab; four wheel drive, bed length, ball-hitch, fifth wheel, etc. The GMC/Chevrolet Trailer Guide states the following for the 2011 GM HD3500 6.6 Duramax crew cab single tire 6.5 box you mentioned. 2WD is 17,200 and 4WD...

I sure did not mean to walk all over the above posts with my comments to Hillsonwheels. When I signed in all I saw was the post which said "Us dummies gotta know" and saw no other posts. After posting my comments I then saw all others. Rick, thanks for your additional information and what...