Search results

I looked long and hard for my 2003 Cummins with 6spd std. It has the best of all worlds-no pollution control and no worries about an underbuilt Dodge automatic trans. I can get in the mid to high 20mpg when MT and do 12 to 14 pulling our Landmark Shenandougha. If you are in the market for a new...

I got a phone number for Heartland Service and gave it a try-got some good info. I was directed to a local dealer (1 hour away) who is a Heartland Dealer. They want $140/hr for this job. They have done a number of them, apparently. They almost suggested Heartland has been contributing some...

Well we got bit by the potable water tank falling down. I was under the slide lubing the slides and all of a sudden there was crack and the tank was hanging below the frame a good 4 to 5". We are just loading up to go for 4 days then 4 weeks-good timing. I don't know what they have for a tank...

Well yet another deficiency in this 2006 Landmark. After 65 hrs. I thought I had them all- not so. We just returned from 2 weeks at lake-every time we flush the wc-we get a huge release of gas. It is violent enough to blow the WC bowl contents up and out-hence we do not flush without closing the...

If anybody is interested in reading an actual test of fuel additives there is one on line. It has copywrite by The Diesel Place and Arlen Spicer. I have all 11 pages of it but I can't find the original on line address. Is it out of places to attach it here? Just found a link to a copy...

After getting rid of the supplied sound system I was looking over some of the cable TV system. There is a series of switches in the cabinet at the entrance door with all sorts of labels on each switch- but there are no instructions about what goes to where by switching each of them. Is there...

2006 Landmark Shenandoah- new to us as of last fall. I flushed the glycol from winter and filled the water tank in the normal fashion by placing hose into tank fill receptacle- eventually water started coming out one of three pipes at rear underneath-equivalent to in front of fireplace. Why is...

I just did one big stupid late this afternoon. I've been working on the new to us unit and have finally finished most things. The unit was sitting in the middle of the driveway with all the slides out, and a big snow storm is on its way. Decided to close it up for the rest of the winter and move...

Lieppert will have to learn to yield to the consumer rather than the bean counter. There are many jurisdictions where we can carry a trailer behind the 5th wheel. I think it reasonable to limit it to max 5,000lb.I know how unbending they can be. Friends of ours bought their 40' Landmark...

I think it time to think ahead of problem solving rather than problem overwhelming. I was impressed with one aspect of my old class A Winnie Luxor DP-that was the FG roof. It had about 5" of bonded styrofoam that made that roof reasonably solid-even for a 300 lb. light footed guy like me. That...

Finished my electrical tricks. I took out the fireplace and found all the problems located behind the panelling on the wall behind FP. Found where screw went through wire, used it to pull new wire to GFI @ kitchen. Found where they had coupled ground & neutral together. Ran three new strand 14/3...

I've worked for a few decades in HVAC and so wiring & trouble shooting is not new. I did in fact find a screw through a 14/2 wire. When jiggled it would create a short-as measured on my multimeter. As there are no other junction boxes showing-by deduction there has to be a hidden junction...

The microwave plug was the first clue-it was hanging a little loose. Just checking every ckt. after my inverter install & found what I thought was no power at microwave. Turns out there was power at L1, but L1 was shorted to neutral. I traced it from panel to junction box just under slide-...

I suffer from the loose adjusting nut syndrome on both my door side and kitchen side slide. I have read and re-read the postings on others who have had the loose adjusting nut problem. I have also read the Liebert manual and found it contradictory. On the same page it states if you need the...

Well that was a few days from centre earth. This fat old boy jambed into that basement compartment, but I managed to wire in a Progressive Dynamics transfer switch with my new inverter hopefully protected by it. Took the battery tray out of stock battery box and reinforced the box and 2- 6 volts...

The tray is factory, it seals the battery compartment from the basement and the adjacent compartment. Local Costco made my decision for me. They are cleaning out 6 volt GC batteries 220 Ahr- they look like interstate- great price $49.97 per. So I bought 4 of them, plus I landed a Royal Power...

I only have a single group 24 Marine/deep cycle battery & want to increase my capacity. Who was the mother's child who designed the battery compartment on my 2006 Landmark? It has a slide out plastic shelf/tray that is 14" x12"- but here is the kicker-I only have 10 1/2" H. I was thinking 2-6...

I don't think the PO had anything to do with this switch. It looks like a factory job. I have to crawl into the basement tomorrow as in my investigations I can see daylight around the perimeter and the insulation is pulled back from the edge of the belly cover. I'm thinking spray foam might be...

You're right-it is a 2006. I found the switch for the slides. This switch is a very small rocker on/off switch

Good day- we just got our new to us 2004 Landmark Shenandoah home and am in the process of discovery. In the battery compartment there is a three part bus, a 12 volt mater disconnect switch, and then another small on/off rocker switch which activates what??? Any help would be appreciated. As...

Having just left the darkside (Winnebago) I am the "new to us" owner of a 2006 Landmark Shenandoah 34'. I cannot find the resources on the Heartland home site that Winnebago has on their site. I was able to access all build details, wiring diagrams, wiring locations, part numbers, supplier...