Search results

  1. J

    ATF: Cyclone - 50 Amp AC Cord/Plug

    Have a 2012 Cyclone 3950 w/50 amp AC service. Incoming power cord has a threaded collar/ring that secures the plug to the trailer and helps prevent water intrusion. Somehow I have lost the threaded collar/ring off the plug. Can I obtain another threaded ring so I don't have to cut the old plug...
  2. J

    Do you leave ladder on side while towing?

    Thanks for comments, especially from CA. JohnnyR
  3. J

    Do you leave ladder on side while towing?

    2012 3950 Cyclone. Question is whether you leave your detachable ladder attached to side of your toyhauler while towing? I seem to remember most that I see on the road in Texas leave theirs attached as I have. Towed out to CA earlier this year with it attached and had no problems. About to go...
  4. J

    Tire wear on triple axle models?

    Thanks for all the comments. Much appreciated.
  5. J

    Tire wear on triple axle models?

    Have a 2012 Cyclone 3950 toyhauler with three axles. Probably have about 12K miles on the tires. Noticed that tires on front axle and rear axle show more wear than tires on center axle, especially on tire edges. Does not appear to be axle misalignment as tires not worn only on outside vs iside...
  6. J

    How does roof ladder attach? 2012 Cyclone 3950

    Got too close to a tree limb and it pulled one of the upper stanchions out of the collar that attaches to the roof for the side ladder on my toy hauler. Trying to figure out how the upper portion to which side ladder is mounted attaches to roof. I think the stanchion/tubing attaches to the...
  7. J

    Front Hydrulic Jack Malfunction

    Heartland removed the allen screw valves for 2012. Said they leaked too much. Anyway, if I need to lift with an external jack, where do I position the jack or jacks?
  8. J

    Front Hydrulic Jack Malfunction

    Yes, pump runs when i actuate the slide switch.
  9. J

    Front Hydrulic Jack Malfunction

    2012 Cyclone 3950 Hooked upto the trailer. Retracted front jacks and one side would not retract fully. Tried to extend jacks again and retract again and both sides would do nothing after extending a bunch when i pushed the jack switch. Now will not retract, will not extend. Checked the fuse and...
  10. J

    Coleman Grill Hookup

    Recently purchased a Coleman LXE Roadtrip grill that uses the 16 oz portable cylinders. To hook up to the quick connect fitting/plumbing already one my Cyclone 3950, one needs to remove the regulator on the grill as the propane from the trailer is already been thru a regulator. Has anyone found...
  11. J

    Hookup for blackwater tank flush

    Thx, John. That helps a lot. So do you know why the winterizer extendable hose is not standard hose diameter fitting?
  12. J

    Mounting a Wheeldock

    My 2012 3950 HD has a some kind of bottom cover so I gotta pull that to see what goes where. Anyway looks like most everybody is attaching their chock to the plywood 1 inch floor in lieu of frame with no problems.
  13. J

    Hookup for blackwater tank flush

    Have a 2012 Cyclone 3950 toyhauler with 1 1/2 baths. Bought it used and the manual does not fully answer following questions: 1. Does the blackwater flush system flusk both the front and rear blackwater tanks (rear being for the extra half bath in the garage), or just the front tank beneath the...
  14. J

    Noise when heater come on

    Thanks for replies. Erika, the rumbling is what am hearing. As for normal, at least I'm not the only one experiencing it.
  15. J

    Noise when heater come on

    2012 Cyclone 3950HD. Right after gas heater ignites, there is a roaring noise for about 3 to 5 secondss. Noise stops for 5-10 seconds then does it again for 3-5 seconds. It is as if the heater goes into a turbo mode, for lack of a better description, for these brief periods. Heater works fine...
  16. J

    Mounting a Wheeldock

    Recently purchased a 2012 Cyclone 3950HD. Need advice on best/easiest way to install a Wheeldock for my Honda GL1800. I assume i need to pull the bottom cover to expose frame and drill thru frame members, in lieu of plywood floor only, for a bike that heavy (900 lbs). Or is there a way to mount...
Top