Search results

Re: Slide does not extend the same on both sides Love it when simple works Sent from my SCH-I545 using Tapatalk

We used a truckers guide and it listed all highway restrictions on truck routes. Most western states are good but tunnels can be problematic. Usually low clearances are marked. Sent from my SCH-I545 using Tapatalk

Alan...hard to take pics of Plexiglas but here goes. One picture is behind pantry. I fastened to wall with small stainless finish screws and grommet washers. Drill oversized hole through Plexiglas ad small pilot hole into wall. The Plexiglas can be found at Home Depot or Lowes and purchased...

We have a 2017 M231. The kitchen and cooking area has wallpaper which can pickup cooking greases and splashes. We installed Plexiglas sheets overhe wall paper which is easy clean.

I was able to easily find the backer plate and tv install went perfectly.

Glad you were able to resolve your problem. We also have a new Mallard M231 and in reading the manufacturer's info there is a 15 amp mini fuse which blows if reverse polarity is detected. I like to have spare fuses but could not find the one listed. It looks like a standard 140a mini fuse so...

Thank you Ron for the glow in the dark tape suggestion. I went ahead and ordered a roll for our stairs which have no light. I might also stick on my awning rails which seem attracted to my forehead...tim

We just purchased a new Mallard M231 and have the same problem. There is an outside light above the door but the light is blocked when the door is open. Also there is good lighting when the awning is out but that is rarely the case. I would like to add a light at or behind steps but not sure...

Looks great Kevin..our install almost identical just a different brand of switch..tim

We are now in the middle of our first trip in new Mallard M231. We have traveled from Bakersfield to Mesa, Arizona. We recently sold Tiffin Allegro Bus and are in the middle of switching to a park model. The M231 was recently purchased for shorter trips and to travel between California and...

We purchased a Mallard M231 in November 2016. I ordered a cutoff switch from Amazon and installed it on the battery cover. The install was easy and quick and it works like a charm.

The heat pumps we have had were not recommended for use much below 45 degrees. Damage can occur

Thanks Dan...the connection is setup for a plug and play install. The dealer said there were several brands that would plug directly into the connection and the portable panels would come with controller. I have found several that meet my requirement that connect directly onto battery or I...

Dan...thanks. Guess I was not that clear. What I meant was the inside (interior) of an outside wall. Sorry I didn't mean to imply on the exterior.

My wife and I recently purchased the Mallard IDM231. I would like to mount a TV to the outside wall adjacent to the TV connections. The many comments here suggest that there may be a mounting plate behind the wall with a sticker or to push on the wall trying to located the frame. The wall is...

My wife and I recently purchased the Mallard IDM231. Among many things we were attracted to the solar ready receptacle. I am interested in a portable panel that generates 100-150 watts with a longer cord so I can set the panel on the roof during storage. I have found no information from...

Thanx..guess I'll drill some small holes..no labels on our wall near connections

Thanks John..were you able to mount into frame. I am assuming where the wall paper has a splice and cover will match where aluminum frame is?

Just acquired above Mallard and looking to install TV on swivel mount. Anyone have suggestions?

New to this forum and travel trailers. Recently purchased the above Mallard and trying to equip for occasional boon docking and storage. The trailer came solar ready but the operating manual provided little information on what to e look for in solar equipment. Plan to use for short term...