Search results

2010 Sundance 2900MK When the pocket door is moved inside the pocket all the way the door hangs out of plumb as the bottom is kicked out into the walkway. Seems like the rear track screws are loose which allows the pocket door to sag from the rear resulting in the out of plumb door. any...

Ref: 2010 , Hearland Sundance, the switch works fine underload extending the legs. When I attempt to raise the legs it blows the 30 amp fuse. Works fine manually like there is nothing binding in the gear box. All electrical connections are tight and the batteries are at 13+ amps What am I...

I need to remove a good portion of my coroplas to repair a water leak and replace a grey tank valve. looks like I will need to slit the material to get around the grey and black PVC lines. What seems the best method to repair the coroplas liner? Appreciate your help.

On our 2010 Sundance the screws that hold the Screen door latch in place keep loosening. Redrilled and added new screws but reoccured. Tried to remove the door moulding to get in behind the interior skin and add bolts but it is laminated to the styro insulation. How have others solved this...

2010 Sundance 2900 Mk The right rear and back end have begun to separate at the bottom corner . the side has bulged out about 3/4 of an inch and corner trim no longer covers the corner. One solution might be to install a 3" angle corner and secure it to aluminum verticals. I don't want to pull...

Big surprise when my entry door glass shattered and we quickly observed the lack of tempered glass. Would of expected better. Original glass on a 2010 Heartland Sundance MK 2900.Be aware.

Looking for ideas to increase the stability of our kitchen table. We never use it as a bed so it could be mounted permanently. Suggestions?

Looking for recommendation on Suppliers for "D" type slide seals. Mount on top of slides wipes. 1" x. 15 /16". Appreciate your input. .

I have a 2015 Ram 3500 with a camera in the tailgate that I would like to remove and install in my fifth wheel free flow tailgate. The disconnect plug is there for remounting, just looking for those who have already experienced the learning curve. Thanks. Sunriverman

Looking at the new 3500 Ram. Rear bed height is 39 -40". Seems like that height creates problems in getting a level 5th wheel with my New Reese Titan hitch. Any thoughts?

While rewiring the rear stabilizer switch I noticed the black fabric covering the vertical rear overhang on the underside has worn and needs attention. The continuous spray action from the tires and fine dirt have created the damage. I tried using a truck bed liner spray and several coats and...

I have noticed that the hitch pin on my 2010 Sundance MK2900 has begun to have a wear point on the back side creating a little slop in starting and stopping. Has anyone had a welding shop build the wear point back up and then grind it smooth again? Might there be other solutions? Thanks. Rod

When checking the voltage of the two wires supplying power to the stabilizer switch, one red and one white wire, I am only getting 6+ volts. Do I have an open wire or bad contact somewhere? Thanks for your help

It's time to replace the swivel rocker chairs in our MK 2900 after three years. Would appreciate your advise and insight as depth of the chair is a challenge. Rod and Gail

Hard to believe but my new Camping World Fifth Wheel cover actually wore a small hole in my rubber roof during storage this winter. Guess the movement of the cover was excessive as there is a small wear spot on the edge of roof where it transitions to the side. Wear spot is one inch long by...

On our 2010 Sundance 2900MK the positive goes from the batteries to the buss bar and then out to the circuits. There is only one inline fuse in the front compartment and that is for the front landing gear motor. There are no minreset breakers as some have mentioned. My question is where is the...

We have a 2010 Sundance 2900MK which we have been very pleased with and has over 30,000 in two seasons. Recently we discovered the rear stabilizer jacks do not operate using the 12 volt switch. I don't seem to find an in-line fuse for the stabilizer motor like the front jacks. Any suggestions...

Where might I look to learn about the holding tank valves, how the cable connect and trouble-shooting. Has anyone just bypassed the cables and installed exterior manual valves? My kitchen sink tank valve works very hard and I am anticipating the instalation of a manual valve and eliminate...

Here on Lake Hebgan, Montana for the last month. While waxing my unit I noticed pitch on the slide out roofs. Any suggestions to remove the sticky stuff?

I would like to wire in a 12 volt outlet to facilitate my Resmed breathing machine. What wire size and fuse should I use? Secondly, when charging my dual 6 volt batteries I am assuming from the posts I have read that I should disconnect the batteries from the rv and connect directly to the...

I just noticed my Sundance MK 2900 has a grease fitting on the on the pivot rubber bracket that where the two axle springs join. Nothing in the manual or dealer walk-thru. How often do you add a shot of grease to the fitting? thanks for your thoughts.

Aside from today's snow can anyone shed light on this section of Hwy 550. Looks like three passes all over 10,000' ! Is this route RV frinedly or should I take I-40 west out of Albuquerque and then 89 north to eventually get to Grand Junction. Appreciate any help.

Sitting here on the banks of the Sacramento River trying to not watch The Bachelor. We are hooked to cable and were able to get 60 channels on the main TV and after programing the bedroom tv can only receive five channels. Should we get the same channels with both sets? I assume the bedroom...

I am helping a friend who is considering a new Sundance 2900 or 3100 fifth wheel. He is concerned after reading all the posts re frame failures and springs, spring hangers, and bolt problems. Have there been many of these problems with the Sundance models mentioned or are these units lighter and...

Sundance 2010, 2900 MK: On my two big slides I have the normal 2" x 2" square tubes with gear teeth on the bottom. Then there is a bronze colored round tube with a threaded cup and lock nuts that parallel the main slide tubes. I notice the lock not on the threaded cup was backed off. What is the...

When I extend the slides on our new MK 2900 I continually am getting grey caulking sticking to the sides of the pushout as well as the dinette window.The caulk was factory installed and then over-coated with a white caulking. Seems like the white peels off and the grey is a mess on the rubber...

We enjoy our new Sundance MK2900 but wonder if anyone has put a drain in their docking station. Seems like we always get a little water sitting on the bottom of the basin. Also had a leak weeping from the pressure water connection which weeped back in behind, ran down and got the floor of my...

Deliver this afternoon of our new Sundance 2900MK fifth wheel. Dealer is offering seven year extended warranty of coach etc for $2995. Any claims not used against the $2995 is refunded. Also 7 year protection on tires and rims for $495, includes replacement due to anything except lack of tire...

Just returned from the dealer and purchased a new 2010 Sundance, 2900MK. My question relates to the "acrylic sealer" for the exterior surfaces. Is it worth the $1450 or $1885 which included interior fabice and carpet treatment as well? Thanks in advance for your opinion. SRman