MallardHead
Well-known member
Who uses the Anderson Levelers??? Pros..... Cons.....
Last edited by a moderator:
Anderson Levelers
- Thread starter MallardHead
- Start date
Bones
Well-known member
I use them. They work great. The only complaint I would have is I wish they were a little bit wider. When using them you will have to decide if you want to back onto them or pull up onto them.
MP_CS
Well-known member
I have them and they work great. I dont use them often because my axles are close enough together that the front one is very difficult to remove. If you dont have someone pull it out as your pulling off them it will wedge itself in between the tires. Its dangerous if you arent being extremely carefull.
MallardHead
Well-known member
I have plenty of the lynx blocks and have used them on my previous TT and Popup ....Only thing with them I aways have issues with them are if I only need to raise the low side just a little bit the leveling blocks always were to much...Any advice on that
Kevin & Kandy Jones
HOC Member #3501
2017 Mallard M32
JohnD
Moved on to the next thing...
I have plenty of the lynx blocks and have used them on my previous TT and Popup ....Only thing with them I aways have issues with them are if I only need to raise the low side just a little bit the leveling blocks always were to much...Any advice on that
Kevin & Kandy Jones
HOC Member #3501
2017 Mallard M32
Sometimes it is just easier to live with one side being a little higher or lower than the other.
However, I bought some of these (had them in the parts store at our dealership):
https://www.amazon.com/Tri-Lynx-000...&qid=1483048782&sr=8-3&keywords=lynx+levelers
These caps add about a half of one of the blocks and are awesome!
I'm going to buy another set of four soon!
MallardHead
Well-known member
Actually not a bad idea .... I guess if only needed to raise about 1/2 inch could just put 1 of these under each tire on the low side and drive up on that instead of a whole lynx block..... never thought of that
Kevin & Kandy Jones
HOC Member #3501
2017 Mallard M32
Kevin & Kandy Jones
HOC Member #3501
2017 Mallard M32
MallardHead
Well-known member
How do you like the device between the wheels.... I have the wide trax system on our Mallard so not sure if will work
Kevin & Kandy Jones
HOC Member #3501
2017 Mallard M32
MallardHead
Well-known member
Cool..... they are on my shopping list once I find the right ones for the wider gap
Kevin & Kandy Jones
HOC Member #3501
2017 Mallard M32
JohnD
Moved on to the next thing...
You can get them from Camping World . . . they carry both sizes!
MallardHead
Well-known member
Will give it a look.....thanks for all the information....very valuable
Kevin & Kandy Jones
HOC Member #3501
2017 Mallard M32
