Little help please! There are two rails which the slideout rides upon. At the end of each rail is a bifurcated tang which is bent at about a 15 degree angle. One of the rails has a stop which is adjustable, it is aluminum and mounts via a set screw. The other rail looks like it formerly also had a travel stop (there is a mark where the set screw used to be).
Questions:
1) should each rail have a travel stop?
2) If so, how do I get a new one to replace the missing one?
3) How does one adjust the stop?
4) In general, is it the stop which limits the inboard travel of the slide, or is there a microswitch or something else?
5) Is there a manual for the slideout?
The bottom of my slideout is now bowed out a little. I would like to prevent this from getting worse. Thanks in advance!
Questions:
1) should each rail have a travel stop?
2) If so, how do I get a new one to replace the missing one?
3) How does one adjust the stop?
4) In general, is it the stop which limits the inboard travel of the slide, or is there a microswitch or something else?
5) Is there a manual for the slideout?
The bottom of my slideout is now bowed out a little. I would like to prevent this from getting worse. Thanks in advance!