wdk450
Well-known member
Gang:
My freeze senor looks like this:
The sensor "puck" can be adjusted in and out within the wire clip, bringing it closer/farther to the condenser coil. Is it supposed to TOUCH the condenser coil or be spaced away? This should be on the INTAKE air flow side of the condenser, right?? That's where the fin deformations originally were.
I was thinking that my compressor is switched off too much. I may have to run up on the roof when it is off and look for condenser ice.
Dometic customer service has 15 in telephone wait queue right now. Manual doesn't specifically address this.
My freeze senor looks like this:
The sensor "puck" can be adjusted in and out within the wire clip, bringing it closer/farther to the condenser coil. Is it supposed to TOUCH the condenser coil or be spaced away? This should be on the INTAKE air flow side of the condenser, right?? That's where the fin deformations originally were.
I was thinking that my compressor is switched off too much. I may have to run up on the roof when it is off and look for condenser ice.
Dometic customer service has 15 in telephone wait queue right now. Manual doesn't specifically address this.
