Relayman
Well-known member
you can't really tell from the photos. Sorry. You get some square foam blanks at Home Depot or Lowes, glue them together so you have a 2" thick foam blank. measure the ID of your duct cut a piece to fit , then
cut and shape it into a " scoop"
shape , then cut it into a couple of pieces you can wedge into the end ducts, then tape them in place using HVAC foil duct tape.
This forces more air down into your living area. In the middle duct , I used a plastic jug ( you may use a plastic coffee can or anything elese ) with a shaoe so I could cut the plastic out to form a
"half-scoop" , that goes into the middle supply air opening ,but only covers half of the duct ( to allow some air to flow past and to the rear ) curved downward and taped into place , to divert more air out if the register in the center
of your space. This was only for the living area. In the bedroom , I blocked off the duct just oast the shower skylight. ( this seperated the supply air duct-work from the
living area duct-work. ( my shower skylight on my 3270RS,
blocked off about half of it anyway) . Hpe this kinda gives you an idea.
Sent from my SM-G930V using Tapatalk
