Just got a 2009 Cyclone, have been finding more and more wrong as I go through it. I have not been able to get any hot water yet. I can get the system to ignite 12V, LP system and run for about 5 minutes then it shuts off and wont restart. I had to push the right reset button a couple times, but this last time it did not pop it. I went through all the trouble shooting procedures finding nothing wrong with the 12v switches, but no power to the 110v side of things. As I was sitting there testing the system with the secondary switch off, it ignited up again randomly. I have run water through the faucets hot and cold side. The hot side water pressure is a lot less than the cold faucet. I cant seem to figure out how to check to make sure that there is water in the water heater though? Winterization switch is pointing to normal operation.