Ann&Ted
Well-known member
I have several leaks in the vinyl 1/4 inch line that I installed the plastic connectors in order to repair the leaks. Fortunately, they drip. Not as bad as the hard spray that a small hole in the line causes. After 2 leaks, I realize that I need to replace the line between the 2 valves (1 is shown in the picture). Has anyone every just replaced the line between valves, without replacing the valve, or the entire line from refrigerator to water tank? I have not been able to find this type valve on the internet so am not sure how to just pull out the water line and reinstall a new line without breaking the valve. I may be as easy as just yanking out the line from the valve, but if I break the fitting, I will need to get new valves. Any suggestions before I try and break something?
Thanks for any information.
Thanks for any information.